Brizo ASME A112.18.1 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Brizo ASME A112.18.1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brizo ASME A112.18.1 20 페이지. Multichoice valve trim

Cartridge Installation

Turn off water supplies. Remove cover (1),

bonnet nut (2) and test cap (3) from the body. If

this is not a thin wall mounting, the entire plas-

terguard (4) may be removed. If screen (5) is in

place, remove before installing cartridge.

Slide bonnet nut (1) over the cartridge and

thread onto the body. Hand tighten securely.

Rotate the cartridge (1) so the word "UP" (2)

appears on the top. Insert cartridge into valve

body as shown. Make sure the cartridge tubes

and O-rings (3) are properly seated in holes at

the base of the body. Ensure the keys on the

body are fully engaged with the slots in the

body (4).

Back to back Installation

Normal Installation

(changes not required)

Reverse

Installation

For back to back or reverse installations

(hot on right and cold on left): Rotate cartridge

(1) so the word "UP" (2) appears on the bottom.

Install the cartridge making sure that the keys are

fully engaged with the slots in the brass body (see

step B). Slide bonnet nut (3) over the cartridge and

thread onto the body. Hand tighten securely.

60 Series Installation

Cold

Hot