Avanti BCF54S3S 사용 설명서 - 페이지 9
{카테고리_이름} Avanti BCF54S3S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avanti BCF54S3S 20 페이지. Beverage cooler
페이지 인쇄
BEFORE USING YOUR BEVERAGE COOLER
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
1
Instruction Manual
3
Beverage Shelves (2 Wire shelves / 1 Glass shelf)
1
Wooden Shelf with 90% pull-out assembly
2
Keys
1 Set
Stainless Steel Hinges for Door Swing Reversal
2
Hinge Screw caps
1
Stainless Steel Handle
•
Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR BEVERAGE COOLER
•
This appliance is designed to be for free standing installation or built-in (fully recessed).
•
Place your Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Beverage Cooler, adjust the front leveling legs at the bottom of the
Beverage Cooler.
•
Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing
installation. If you plan to use this unit in a built-in application
please follow the requirements shown to the right.
Unit Dimensions
Width
Depth
(with handle)
Depth
(without handle)
Height
INSTALLATION INSTRUCTIONS
Figure shown
IN (min)
MM (min)
1
597 mm
"
23
/
2
1
25
/
"
641 mm
4
1
23
/
"
597 mm
2
3
33
/
"
857 mm
4
←
Figure shown
Cabinet Opening Dimensions
Width
Depth
Height
→
9
IN (min)
MM (min)
24"
610 mm
26"
661 mm
35"
889 mm