GARDECO Sedgley 조립 및 사용 설명서 - 페이지 7

{카테고리_이름} GARDECO Sedgley에 대한 조립 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDECO Sedgley 13 페이지. Black country stove

4. The main flue, cowl and funnel must be made of high grade stainless steel. The outer flue and the

flashing must be made of zinc-alum or galvanized. The main and outer flue sections must be fastened

together with stainless steel screws or rivets; use three rivets/screws at each join on both the main

and outer flue.

IMPORTANT: The main flue pipe unions must be done in such a way that the upper section(s) fits

inside the lower one(s). The outer flue section(s) should be done inversely, with the lower section

inside the upper.

5. The cowl, funnel and the upper edge of the main flue must be screwed or riveted to one another

(provided on inside cover of box). The funnel must be free from the outer flue to allow for thermal

expansion.

This union must not be screwed/riveted.

6. You must thoroughly waterproof the flashing where it meets the roof sheeting and where the

outer flue goes through the flashing. Consult your hardware or specialist waterproofing company for

the most suitable products and techniques. If the outer flue extends more than one meter

above the roof,

or if the area is windy,

use tension

wires to fasten

DOWN DRAFT: If wind collides with an obstacle, there will be turbulence that can

cause smoke to blow back down the flue (down draft). To correct this situation,

the outer flue

increase the length of the flue so that it projects over the turbulence area.

to the roof.

STAIRCASE: If the fireplace is positioned near a staircase, the heat will flow towards

the upper levels and will not sufficiently heat the lower level. This can be corrected

by fixing a lintel above the staircase, thereby distributing hot air around the lower

level ceiling.

USEFUL HINTS

lintel