2M2 FENCE Glass fence 매뉴얼 - 페이지 3

{카테고리_이름} 2M2 FENCE Glass fence에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2M2 FENCE Glass fence 8 페이지.

페이지 인쇄

Glass_fence_ 2.0 ny2 171109.pdf

Ø3mm

COMBINATION

2017-11-14

13:35

Ø9mm

CARE INSTRUCTIONS:

Glass

: Soft cloth, water, window cleaner. Only use mild, weak, non-corrosive detergents.

Aluminium : Soft cloth/brush, water. Only use mild, weak, non-corrosive detergents.

Screws

: Regularly check the attachments, screws, etc. and tighten if necessary.

ASSEMBLY INSTRUCTIONS FOR GLASS FENCE

Assembling the fence and poles:

•

Start by planning where you want your fence and

make sure that the surface is level. Note that the

maximum assembly height above ground is 100 cm.

Start by putting the glass fence section vertical.

•

The end with the pre-drilled holes in the aluminium

edging must be at the top.

•

Put the fence between the two posts and drill holes

in the post using the drill bit that is included (ﬁ g. 1).

•

Then attach the fence section using the 4 screws

that are included (ﬁ g. 1).

•

Mark the four holes in the base of the post onto

the surface where the fence section will go. Move

the fence section and pre-drill/drill (9 mm) into the

surface. Attach the fence and move onto the next

section by following the same procedure until you

have assembled all of the fence.

NOTE! The 8 mm assembly screws are purchased

separately as they will vary depending

on the surface.

Recommended screws for bottom plate:

Concrete ground: 8 mm concrete screw

Wooden ground: 8 mm wood screw

A –

97.6 cm glass

B –

22.6 cm glass

C –

End pole

D –

Corner pole

E –

Middle pole