Airfree Iris 2000 사용 설명서 - 페이지 4

{카테고리_이름} Airfree Iris 2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airfree Iris 2000 8 페이지.

Guide for Airfree

installation in mold contaminated rooms

1 - Install your Airfree

2 - Allow your unit to run for at least one week to achieve significant airborne mold spore reduction.

3 - Clean mold infected items and surfaces, since they are a continuous source of new spores.

It is important to stress that Airfree

surfaces must be cleaned manually.

Airfree

will destroy airbone molds, spores and prevents them from contaminating other areas, inhibiting the

growth of existing and new colonies.

Plug power cord into the nearest outlet. Make sure the surface is dry (never place Airfree

wet floor or immerge it in water). Make sure side led light is on. Adjust the night light intensity

with the touch sensor. After 10 minutes the top lid should be warm.

Place Airfree

or behind curtains as it will reduce airflow and Airfree

Check if the area is compatible with the unit capacity to achieve best unit performance.

Airfree

However it is recommended not to place nearby to avoid potential interference in Airfree

air flow.

Airfree

connecting rooms.

Airfree

room.

To change top light colors press the sensor on the top of Airfree's logo. Each touch will switch

to the next color. For the random mode please switch to pink and let it be. Maintaining finger

pressed on the sensor will increase or diminish brighteness.

Airfree

unit in accordance with the user manual

will not destroy or remove mold from an infected item or surface. Those

Installing and Connecting

on a flat surface not exceeding 3' from the floor, not under furniture, shelves,

must be continuously on in the same room, 24 hours a day.

is to be used in rooms with minimum air volume of 330 ft

can be installed in rooms equipped with air conditioning and heating systems.

can be placed in corridors but its air sterilization effects will barely have any effect in

shall not be placed near doors or under windows to avoid sterilized air to exit the

and Mold

efficiency in reducing microorganisms.