HIKVISION DS-9100HFI-ST 빠른 작동 매뉴얼 - 페이지 4

{카테고리_이름} HIKVISION DS-9100HFI-ST에 대한 빠른 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-9100HFI-ST 19 페이지. Ds-9100hfi-st series

페이지 인쇄

Quick Operation Guide of DS-9100HFI-ST Series DVR

Front Panel

No.

Name

ALARM

READY

STATUS

HDD

MODEM

TX/RX

GUARD

IR Receiver

Front Panel Lock

DVD-ROM

Alphanumeric Buttons

USB Interfaces

ESC

REC/SHOT

PLAY/AUTO

Function Description

Alarm indicator turns red when a sensor alarm is detected.

Ready indicator is normally green, indicating that the DVR is functioning

properly.

Status indicator turns green when DVR is controlled by an IR remote.

Indicator turns red when controlled by a keyboard and purple when IR

remote and keyboard is used at the same time.

HDD indicator blinks red when data is being read from or written to HDD.

Reserved for future usage.

TX/RX indictor blinks green when network connection is functioning

properly.

Guard indicator turns green when the device is in armed status; at this time,

an alarm is enabled when an event is detected. The indicator turns off when

the device is unarmed. The arm/disarm status can be changed by pressing

and holding on the ESC button for more than 3 seconds in live view mode.

Receiver for IR remote

You can lock or unlock the panel by the key.

Slot for DVD-ROM. (Optional)

•

Switching to the corresponding channel in Live view or PTZ Control

mode.

•

Inputting numbers and characters in Edit mode.

•

Switching between different channels in Playback mode.

•

The light of the button is green when the corresponding channel is

recording; it is red when the channel is in network transmission status; it is

pink when the channel is recording and transmitting.

Universal Serial Bus (USB) ports for additional devices such as USB mouse

and USB Hard Disk Drive (HDD).

Back to the previous menu

Pressing for Arming/disarming the DVR in Live View mode.

Entering the Manual Record setting menu. In PTZ control settings, press the

REC/SHOT button and then you can call a PTZ preset by pressing Numeric

button.

The PLAY/AUTO button is used to enter the Playback menu. It is also used

to turn audio on/off in the Playback menu and auto scan in the PTZ Control

menu.