HIKVISION DS-9116HFI-ST series 빠른 작동 매뉴얼 - 페이지 2

{카테고리_이름} HIKVISION DS-9116HFI-ST series에 대한 빠른 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-9116HFI-ST series 19 페이지. Ds-9100hfi-st series

Quick Operation Guide of DS-9100HFI-ST Series DVR

Verify Contents

Verify that the package contents are correct by checking the items against the packing list.

Note:

Please contact your dealer for damaged or missing items.

The DS-9100HFI-ST Series DVR is highly advanced surveillance equipment that should be installed with care.

Please take into consideration the following precautionary steps before installation of the DVR.

1. Keep all liquids away from the DVR.

2. Install the DVR in a well-ventilated and dust-free area.

3. Ensure environmental conditions meet factory specifications.

4. Install a manufacturer recommended HDD.

During the installation of the DVR:

1. Use brackets for rack mounting.

2. Ensure there is ample room for audio and video cables.

3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.

4. Connect both the alarm and RS-485 cable.

5. Allow at least 2cm (~0.75-inch) of space between racks mounted devices.

6. Ensure the DVR is grounded.

7. Environmental temperature should be within the range of -10 ºC ~ 55 ºC, 14ºF ~ 131ºF.

8. Environmental humidity should be within the range of 10% ~ 90%.

Before you start:

Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A factory

recommended HDD should be used for this installation.

Up to 8 SATA hard disks can be installed on your DVR.

Tools Required: Screwdriver.

Steps:

1. Fasten the hard disk mounting handle to the hard disk with screws.

2. Insert the key and turn in clockwise direction to open the panel lock.