Avanti WCT6C4S-IS 사용 설명서 - 페이지 6

{카테고리_이름} Avanti WCT6C4S-IS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avanti WCT6C4S-IS 20 페이지.

WARNING

Read all instructions before using the Wine Chiller.

DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or abandoned

appliances are still dangerous . . . even if they will "just sit in the garage a few days".

Before you throw away your old Wine Chiller: Take off the door. Leave the

shelves in place so that children may not easily climb inside.

Never allow children to operate, play with, or crawl inside the appliance.

Never clean appliance parts with flammable fluids. The fumes can create a fire

hazard or explosion.

Do not store or use gasoline or any other flammable vapors and liquids in the vicinity

of this or any other appliance. The fumes can create a fire hazard or explosion.

Do not repair or replace any part of the wine chiller or attempt any servicing unless

specifically recommended in the user-maintenance instructions or in published user-

repair instructions. Replace the fuse with the same type.

Ø Before Using Your Wine Chiller

Remove the exterior and interior packing.

Check to be sure you have all of the following parts:

(2) Wire Wine Racks

(1) User's Manual

Clean the interior surface with lukewarm water using a soft cloth.

Ø Installation of Your Wine Chiller

THIS WINE CHILLER IS DESIGNED TO BE FREE STANDING INSTALLATION ONLY, AND

SHOULD NOT BE RECESSED OR BUILT-IN (FULLY RECESSED).

ALLOW 5 INCHES OF SPACE BETWEEN THE BACK AND SIDES OF THE WINE CHILLER,

WHICH ALLOWS THE PROPER AIR CIRCULATION TO COOL THE HEAT SINK.

Place your Wine Chiller on a surface that is strong enough to support it when it is fully loaded.

Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the unit not to perform

properly.

This Wine Chiller uses thermoelectric refrigeration technology (no compressor) and is not

designed for storage in hot areas like garages, warehouses or outdoors.

Avoid locating the unit in moist areas.

Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized Avanti Products service center.

After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3 hours before

placing any items in the compartment.

IMPORTANT SAFETY INSTRUCTIONS

-Save these instructions-

INSTALLATION INSTRUCTIONS

To reduce the risk of fire, electrical shock,

or injury when using your appliance, follow

these basic precautions: