Avanti WDP75 사용 설명서 - 페이지 9

{카테고리_이름} Avanti WDP75에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avanti WDP75 20 페이지. Electronic controlled water dispenser

During "Energy Saver" Program, when you press the "HOT WATER" button, the (red) "HOT" cycle

indicator will be on and water temperature in the reservoir will be heated to 90ºC/194ºF

(approximately 4 minutes). Once the water temperature reaches 90ºC/194ºF the (red) "HOT" cycle

indicator will turn off and will remain off until the "HOT WATER" button in pressed again.

Normal Program:

When the PROGRAM button is released, it's under Normal operation mode and the (orange) NORM

indicator light will displayed. During operation the (red) "HOT" cycle indicator will be on until the

temperature of the water in the reservoir reaches 90ºC/194ºF (approximately 9 minutes). The (red)

"HOT" cycle indicator will turn off and will remain off until the temperature of the water in the reservoir

drops to 81ºC/178ºF at which time the (red) "HOT" cycle indicator will turn on and the cycle will start

again.

When the unit is in "NORMAL PROGRAM" the "HOT WATER" button is non-functional.

Cold Temp (Energy Saver / Normal Modes):

The cold water cycle is not affected by either program and continuously runs to maintain a cold water

temperature between 5ºC/41ºF and 10ºC/50？ºF. Once the "Cold Switch" at the rear of the unit is

turned ON the (blue) "COLD" cycle indicator will be on until the temperature of the water in the

reservoir drops to 7℃/44ºF or less, the (blue) "COLD" cycle indicator will turn off and the cooling cycle

will stop until the temperature reaches 10 /50ºF, at which time the (blue) "COLD" cycle indicator will

turn on again and the cooling cycle will start again.

Light:

When the light button is pushed, the light will turn on. Pushed again, the light will turn off.

NOTE:

THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.

To get hot water:

♦ Slide red safety button to the right and hold while pressing downward on hot water faucet to

dispense hot water.

♦ Safety button will return to its original position when faucet is released.

Cup Dispenser (OPTIONAL)

The cup dispenser may be installed by using the mounting holes (covered with plastic caps) located

near the top of the right side panel of the cooler. The cup dispenser comes equipped with a mounting

bracket and screws and may be ordered by completing the enclosed order form provided with your

instruction manual.

•

Wash the inside of the reservoir with a warm water and baking soda solution. The solution should