Garden Gear D5942 사용 설명서 - 페이지 8

{카테고리_이름} Garden Gear D5942에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garden Gear D5942 17 페이지. Pole chainsaw

Large slot

Adjusting hole

Place the chain around the drive sprocket, then along the top groove of the

guide bar and around the guide bar nose.

Please note: Make sure that the cutting edges of the chain are facing in the

right direction. Position the chain so that the cutting edges on top of the

guide bar face the guide bar nose.

Extension pole and harness

Loosen and remove the locking dial on the rear pole, then pull the extension

pole out about 30cm (1ft) and connect to the front pole. Ensure it is fully

slotted in and engaged; otherwise the power will not be connected.

Note: the protrusion on the extension pole must fit into the slot on the front

pole and be pushed in fully for the chainsaw to operate, it can only be

assembled one way. When connected, tighten both locking dials.

IMPORTANT! If the two sections

are not connected correctly, there

will be intermittent or no power. If this

is so, check the connection is fully

engaged.