HIKVISION ERT-F2 Series 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} HIKVISION ERT-F2 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION ERT-F2 Series 14 페이지.

A C T I V A T I N G Y O U R D E V I C E ( c o n t i n u e d )

1. Use the mouse to draw a pattern among the nine

dots on the screen. Release the mouse when

the pattern is done.

Connect at least four dots to draw the pattern.

Each dot can be connected only once.

2. Draw the pattern again to confirm it. When the

two patterns match, the pattern is configured

successfully.

3. You can use the unlock pattern for future logins.

U S E R L O G I N

If the DVR logs out, you must log in to the device

before operating the menu and other functions.

1. Select the User Name in the drop-down list.

2. Enter the Password.

3. Click OK to log in.

If the admin enters the wrong password seven

times, the account will lock for 60 seconds. If an

operator enters the wrong password five times,

the account will lock for 60 seconds.

S T A R T U P W I Z A R D

The DVR presents users with a Setup Wizard upon startup, which will prompt users step-by-step through

most basic settings. This Wizard will run every time unit boots up until the user unchecks the "Start Wizard

Box." The Startup Wizard will assist in the setup of most of the items covered in this Quick Start Guide.

Please use this QSG as a reference to assist in the setup of the unit.

I N I T I A L I Z E T H E H A R D D R I V E ( I F N E E D E D )

System will beep/display "Do you want to initialize drive" if HDD(s) are not initialized. Click Yes to initialize.

1. Go to Menu > HDD > General.

2. Use the checkboxes to select the HDDs that need to be initialized.

3. Press INIT (factory installed HDDs come initialized; initializing again will erase any record video).

Figure 1-2 Draw the Pattern