GARDEN MASTER GM3023 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} GARDEN MASTER GM3023에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN MASTER GM3023 8 페이지. Gable roof shed
GARDEN MASTER GM3023에 대해서도 마찬가지입니다: 조립 지침 (2 페이지)

페이지 인쇄
GARDEN MASTER GM3023 조립 지침 매뉴얼
STEP 5:

FRONT WALL

1.
Join
1830mm sheet to (D) or (E) 740mm sheet depending on which way door
A
is to swing. Slip
740mm wide sheet with door jamb under door. Use
D
spacer to determine the correct opening size by placing on the bottom flange of
the door jambs. Then rivet
2.
Outside: Rivet channel at corners and every 2nd rib between and through door
jambs and spacer.
3.
Inside: One rivet per sheet at each end up through channel underside and
through door jambs and spacer.
Rivet padbolt to the outside of door using wide flange rivets supplied.
(We recommend you use an 8mm shackle diameter padlock on these pad bolts,
anything smaller may create security issues.)
CHANNEL
SPACER
Fix through the top and bottom of
the channels into the door jamb
and spacer. The door jamb goes on
inside of the channel.
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
FITTING CHANNELS
The higher side of the channel
goes to the inside of the shed.
It is very important to include
the rivets on the underside
of all the channels as they
are structural.
OUTSIDE
channels to tops and bottoms of sheeting.
F
D
J
F
The cutouts go to the inside of
INSIDE
the panel to allow easy fitment
of the end walls on assembly.
Note top and bottom channels
have different cutouts!
If you need advice, call us
If you choose to vary from these instructions your warranty will be impaired.
door
J
J
E
B Drill through to the underside.
Rivet top and underside.
CHANNELS WITH CUTOUTS
TOP
CHANNEL
BOTTOM
CHANNEL
FREE
on
0800 807 433
or email us at [email protected]
YOU WILL NEED:
1 x 1830mm sheet
A
1 x 740mm wide sheet with door
D
jamb attached
Door pre-hinged to 740mm sheet
E
with door jamb
F
2 x 3000mm channels
J
2 x 793mm door spacers
Channels will come
short of the ends of the
sheeting by 10-15mm on
all panels.
F
A
A
A Drill and rivet here.
GARDEN MASTER TIP
To hinge the door on the
opposite side, put the top
channel on the bottom and
the bottom on the top.
Put the padbolt on the
door before erecting the
panels. It will stop the door
swinging around!
B
5