Janam XP30 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Janam XP30에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Janam XP30 10 페이지. Xp series
Janam XP30에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (15 페이지), 빠른 시작 매뉴얼 (7 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

Getting Started (Continued)

C. INSERTING A JANAM DEVICE INTO THE MODEM CRADLE

For best results, insert your Janam mobile device into the cradle as follows:

1. Place the mobile device in cradle, seating the device without trying to join connectors.

2. Tilt-rotate the device forward (bringing top end of unit forward) as you ﬁ rmly apply downward pressure to fully

insert in cradle and join the connectors.

D. INSTALLING A BATTERY IN THE SPARE CHARGING WELL

1. Use only Janam batteries (BA-XP-1 or BA-XP-2).

2. Note position of connectors and, holding battery with label facing up, position battery with connectors aligned.

3. Place the Janam battery into well and snap into place.

4. The standard battery (BA-XP-1) will charge in three hours. The double capacity battery (BA-XP-2) will charge in

approximately six hours.

E. REMOVING A BATTERY FROM THE SPARE CHARGING WELL

Battery removal is smooth and easy when done properly. Follow the instructions below. Do

not force-pull the battery from well.

1. Position hand with index ﬁ nger at position

2. While gently holding down with thumb, slip index ﬁ nger down against battery so that

you feel the edge where battery meets cradle.

3. Press down and forward with index ﬁ nger to lift battery edge.

Janam Technologies

and thumb at position B.

B B