KitchenAid YKFEG500EBS 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} KitchenAid YKFEG500EBS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid YKFEG500EBS 16 페이지. Freestanding
KitchenAid YKFEG500EBS에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (18 페이지)

페이지 인쇄

Product Dimensions

A. 27³⁄₄" (70.5 cm) max. depth with handle

¹⁄₈

B. 47

" (119.7 cm) overall height (max.) with leveling legs

screwed in all the way*

C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed

in all the way*

D. 29⁷⁄₈" (75.9 cm) width

⁵⁄₁₆

E. 25

" (64.3 cm) depth - back of range to front of cooktop**

F. Model/serial/rating plate (located on the frame behind a top

corner of the door or on either side of the drawer)

IMPORTANT: Range must be level after installation. Follow the

instructions in the "Level Range" section. Using the cooktop as a

reference for leveling the range is not recommended.

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

**Front of door and drawer may extend further forward

depending on styling.

Cabinet Dimensions

Cabinet opening dimensions shown are for 25" (64.0 cm)

countertop depth, 24" (61.0 cm) base cabinet depth and

36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood

combination above the range, follow the range hood or

microwave hood combination installation instructions for

dimensional clearances above the cooktop surface.

A freestanding range may be installed next to combustible walls

with zero clearance.

A. 13" (33.0 cm) max. upper cabinet depth

¹⁄₈

B. 30

" (76.5 cm) min. opening width

C. For minimum clearance to top of cooktop, see NOTE*.

D. 30" (76.2 cm) min. opening width

E. Outlet - 8" to 22" (20.3 cm to 55.9 cm) from either cabinet,

7" (17.8 cm) max. from floor

F. Cabinet door or hinges should not extend into the cutout.

*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal

cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant

millboard covered with not less than No. 28 MSG sheet steel,

0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or

0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the

cooking platform and the bottom of an uncovered wood or metal

cabinet.