Empire OP32FB2MF-3 설치 지침 및 사용 설명서 - 페이지 13

{카테고리_이름} Empire OP32FB2MF-3에 대한 설치 지침 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Empire OP32FB2MF-3 16 페이지.

The firebox is designed to accept a gas line for an ANSI

approved burner. Have the gas line installed by a qualified

service person in accordance with all building codes. Consult

local building codes to properly size the gas supply line leading

to the hook-up at the installed burner. The Commonwealth of

Massachusetts requires that a flexible gas connector cannot

exceed three feet in length.

Gas access holes are provided on both sides of the firebox. See

Figure 12. Carefully remove the knockout in the refractory brick

panel using a large standard screwdriver and hammer. First,

place screwdriver in groove next to plug and pry sideways to

pop out main plug. Then remove the remaining concrete in hole

with gentle tapping with ball peen hammer and/or screwdriver. A

masonry drill and bit may also be used to create a clean hole for

the gas line to pass through. See Figure 13.

After the brick panel knockout is removed, the firebox wrap will

have a round metal knockout that must be removed also. Use a

screwdriver to punch out the metal knockout.

WARNING: CONNECTION DIRECTLY TO AN

UNREGULATED L.P. SUPPLY CAN CAUSE AN EXPLOSION.

Vacuum or brush the control compartment at least twice a year.

Follow the maintenance instructions provided with the burner.

33857-4-0117

GAS LINE CONNECTION

TAP AROUND KNOCK-OUT

Note: Use caution when removing the brick panel knockouts to

avoid damaging the brick panel.

Figure 12

TO REMOVE

Figure 13

Page 13