Garden Oasis NEW CASTLE FIREBOWL 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Garden Oasis NEW CASTLE FIREBOWL에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garden Oasis NEW CASTLE FIREBOWL 10 페이지.

ASSEMBLY INSTRUCTIONS

* Please keep these owner's manual for future reference.

*If you have opened the carton and removed all packages, please disregard the STEP 1 and 2. See the STEP 3

directly.

STEP 1. (1) Open the carton and turn it upside down, make sure the 4

pieces of the carton being open up as below Figure STEP 1.

(2) Lift off the carton carefully and be wary of the accessories inside

falling away. Take away the box containing lava rock.

(3) Take all the packing materials away except for the polyfoam

rounding the top of the firebowl. See Figure STEP 1.

STEP 3.

(I) Check each part before using the product. Make sure the gas supply

system is turned "OFF" before assembling. See Figure I.

(II) Open the storing door on the firebowl for the gas tank. See Figure

(III) Put the gas tank in the metal stand. Make sure the gas tank sits on

the metal stand completely. Turn the wing screw on the outer part of

metal stand clockwise to secure the gas tank tightly. See Figure VI.

connecting and operating conditions.

(IV) Locate the battery, remove the plastic cover first. Unscrew the

rubber cap of the Electric Ignitor, place a AAA battery into the battery

case. Make sure the positive pole ("+") towards the cap. Screw the cap

back to the battery case tightly.

Place the lava rock averagely in the fire bowl on the top of the

(V)

firebowl. See Figure III.

** DO NOT COVER THE IGNITION SCREEN when

placing the lava rock into the fire bowl. Always keep

Ignition Screen visible.

** Connect the Pressure-Regulating Valve to the gas tank.

See Figure IV.

1) Turn the cylinder valve clockwise to close the gas supply

on the gas tank.

2) Screw Regulator Coupling clockwise by hand only.

Make sure it is fastened.

See Figure II.

STEP 2. (1) Turn the firebowl heads up on a flat ground.

(2) Cut off the binding tape on the polyfoam and remove all

the polyfoam rounding the top of the firebowl.

(3) Cut off the tie fastened to the regulator at the metal stand

and set it free for installation to Propane Tank.

See Figure STEP 2.

OFF