AirGenerate airtap 설치 매뉴얼 - 페이지 7

{카테고리_이름} AirGenerate airtap에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirGenerate airtap 8 페이지.

Step-by-Step Instructions

14. Now attach the drain hose to the AirTap

drain line.

NOTE: Ensure that the AirTap

can flow out of the system. Be careful, if the AirTap

side of the drain, you may have some flooding. Inspect the unit for a couple of

days to make sure that the condensate water is not logging.

15. Find the copper tube that extends from the back of the AirTap

foam insulation pipe around this tube. You may also cover the hot outlet

pipe coming out of the tank.

16. You can now reconnect the hot water line on the side, and turn on the

cold water supply to the water heater. Once the air has escaped from the

system, go ahead and turn off the faucet(s) that you had turned on.

17. This is a good time to check for leaks in the new connections.

18. You're ready to plug the AirTap

thermostat to 130º F. You may need to lower the temperature if you feel it is

too hot. If the tank is completely filled with cold water, it may require more

than 3 hours before the water reaches the desired temperature.

, and feed it through your

™

tips toward the side of the drain so that water

™

isn't tipped enough to the

™

into an electrical outlet, and set the

™

. Place the

™