Jancy Engineering JB2400 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Jancy Engineering JB2400에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jancy Engineering JB2400 16 페이지.

In order to keep your Jancy Bender in top working order, it is necessary to follow the maintenance schedule

below.

Every use: Inspect machine for damage (i.e. cracked hoses, leaking fittings, etc.).

Every month (40 hours of use): Inject grease into grease fittings at main pivot assembly.

Every year: Drain hydraulic fluid and replace with between 3 to 4 Gal. of fresh/clean Mobile DTE 24, Shell Tullus

32, or equal (100 SUS to 350 SUS at 100 oF). Minimum of 4" from top of tank to oil is needed for proper oil

circulation. DO NOT OVER FILLTANK.

JB2400 voltage conversion

See instruction sheet 0111DOC for complete instructions and diagrams for voltage conversion.

Problem:

Machine does not switch on

Machine stops working

Nothing happens when control lever is moved

Inconsistent bend angles

Wrinkles on internal surface of bend

Excessive ovalization

Necking of material at beginning

and end of bend

maintenance

troubleshooting

Solution:

1) Check plug/power cord.

2) Check power distribution panel and

circuit breaker.

1) Machine overload.

2) Material is too much for machine.

Turn off machine, let it sit for a few seconds,

then switch back on.

3) Move control lever to the down position to

release material.

Bend angle limit switch engaged, move

adjusting collars away from sensor.

Incorrect "adjusted" bend angle used, adjust

"springback" amount.

1) Pressure die and form die may be touching

2) Form die radius is too small for material, refer

Worn pressure die, rotate or replace die.

Pressure die "grabbing" material, spray pressure

die with spray grease.

to chart for correct former.