Empire VSM-18-2 설치 지침 및 사용 설명서 - 페이지 12

{카테고리_이름} Empire VSM-18-2에 대한 설치 지침 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Empire VSM-18-2 20 페이지. Vented slope glaze burner

PIlOT ANd MAIN buRNeR FlAMe CHARACTeRIsTICs

Pilot Flame Pattern (Figure 9)

Figure 8 shows a correct pilot flame pattern. The correct flame will be blue and will extend beyond the thermocouple/thermopile. The

flame will surround the thermocouple/thermopile just below the tip. A slight yellow flame may occur where the pilot flame and main burner

flame meet.

After use, cleaning of the pilot burner may be required for the proper flame. The pilot orifice can be cleaned with high pressure air or by

placing under running water. Pilot orifice must be dry before replacement. Use a pipe cleaner to clean inside the pilot after the pilot orifice

has been removed.

To Remove Pilot Orifice

1. Disconnect the pilot supply line at the pilot burner.

2. Remove pilot orifice from pilot burner. It may be necessary to tap on pilot burner in order to remove the pilot orifice.

Pilot Flame Pattern

Figure 9

If pilot flame pattern is incorrect

•

See Troubleshooting, page 15

Main burner Flame Pattern

The main burner flame will be completely yellow.

Main burner Flame Ignition and extinction

When the main burner is ignited it will take a few seconds for the full flame pattern to develop.

When the main burner is extinguished it will take a few seconds for the flames to disappear. It is normal to have the flames burn down

near the rock wool, as the remaining gas is burned.

Page 12

26284-3-0813