HIKVISION MD5043SD 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} HIKVISION MD5043SD에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION MD5043SD 20 페이지. Mobile video recorder
페이지 인쇄
2.1 Power Cord Wiring
Warning
● In order to ensure the safety of your automobile and device, a fuse is required for wiring of
automobile power and device power.
● Do not connect the power cord to the device before all the cables are connected.
2.1.1 Shutdown Delay
The device starts up when your automobile ignites and shuts down after automobile is off.
Automobile ignition startup and shutdown are realized by positive pole ignition switch (providing
high level signal when the switch closes). Ignition switch is connected to the positive pole of
automobile batteries.
Steps
Note
● The wire connection of the device varies with the automobile ignition models.
● Make sure the connection of ignition switch is correct.
1. Connect DC IN + of the device to the positive pole of automobile batteries, jumping over the
switch of normal automobile power.
2. Connect DC IN - of the device to the negative pole of automobile batteries.
3. Connect ACC of the device to the automobile ignition switch.
4. Place fuse into the fuse holder.
Mobile Video Recorder (-SD) Quick Start Guide
Chapter 2 Device Wiring
Figure 2-1 Power Cord
5