GARDEN SECRETS GS-503 사용자 지침

{카테고리_이름} GARDEN SECRETS GS-503에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN SECRETS GS-503 2 페이지. Solar powered mole & snake repellent
GARDEN SECRETS GS-503에 대해서도 마찬가지입니다: 사용자 지침 (2 페이지)

페이지 인쇄

Solar Powered Mole & Snake Repellent GS-503

Thanks for purchasing our device. Please read and understand these instructions and keep this manual for future

reference.

The solar mole and snake repellent unit is designed to repel moles and snakes by emitting a pulse which moles and

snakes feel as a vibration transmitted through the ground. Moles and snakes then perceive a danger zone, causing

them to evacuate the area. It is not so much a physical barrier but rather creates an area where the snakes and moles

do not want to be.

Operation

The repeller transmits its signal in all directions for approximately 8 ft / 2.5 m. Units can be placed approx. 16

ft / 5 m apart to get optimum coverage. It is always recommended to use two or more units to get the best

results. Place a unit close to retaining walls, rock gardens, old sheds, etc. to drive snakes out from their

hiding places and send them away. When first installing the units, keep children and animals away from the

area for the first hour, in case any snakes are driven out of their hiding places.

The unit works with rechargeable batteries. The solar module runs the unit and charges the battery during

the day. Night-time operation is enabled by the batteries.

When the power button is pressed, the device vibrates and emits light to make sure everything is working

properly, and then it works once every minute for roughly 5 seconds to save battery while getting the best

results.

Installation Procedure

1. Attach the small connector on the wires from the base of the unit's head to the one from the spike section,

and attach the spike to the head of the unit

2. Press "ON" under the head of the unit.

3. Insert the spike into the ground paying attention not to

damage the unit. The spike should be firmly planted

while leaving the base of the head a minimum of 1-2"

above the ground. We suggest using a crowbar to first

make a small hole and gently push the spike in or dig a

small hole and backfill with earth after the unit is in

place. Do not use a mallet, hammer, or excessive force,

as this may damage the unit. As long as you can get the

unit 2/3 of the way into the ground with firm ground

contact, this is proper placement.

4. You can tell the unit is operating if the LED light flashes

as it transmits its signal, and you will feel the vibrations.

5. At times, the unit may need a short time in the sun to

get a boost and start up when first installed. If the unit

stops operating, check/change the battery. This is the

most common reason for the unit to stop operating.

USER INSTRUCTION