Lexmark 651de - X B/W Laser 사용자 설명서 - 페이지 10

{카테고리_이름} Lexmark 651de - X B/W Laser에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark 651de - X B/W Laser 12 페이지. Setup sheet
Lexmark 651de - X B/W Laser에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 문제 해결 매뉴얼 (13 페이지), 정보 매뉴얼 (19 페이지), 설정 시트 (2 페이지)

페이지 인쇄

1. Index

Faxing using the enhanced number pad

Load an original document faceup into the ADF or facedown on the scanner glass.

Notes:

•

Send multi-page faxes through the ADF.

•

Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine

clippings) into the ADF. Place these items on the scanner glass.

If you are loading a document into the ADF, then adjust the paper guides.

Press

. If your printer does not have this button, then press

You will hear a positive tone when the printer is in the home state.

Press *2.

Fax appears.

From the number pad, press the code for the fax job you want to do, and then press

want to fax a two-sided document, press 0222, and then press

Note: After you press

is incapable of performing the request, then you will hear an error tone.

The fax job options:

Fax option

1-sided original

2-sided original

Press 01 followed by the fax number to which you want to send the fax, and then press

If you have set up a fax shortcut, you may use it instead of the whole fax number.

If you loaded your document into the ADF, then the pages will scan automatically and, after a few seconds, the

fax will be sent.

If you loaded your single-page document on the scanner glass, that page will scan, and after a few seconds, the

fax will be sent.

To exit the mode or return to the home state, press

You will hear a positive tone when the printer is in the home state.

Note: If you forget to do this, the printer will revert to the home state after an interval of printer rest.

, you will hear a positive tone. If you have not input the codes correctly, or if the printer

Code

Press 0211

Press 0222

Faxing using the enhanced number pad

. If your printer does not have this button, then press

. For example, if you