Jandy AquaLink RS 설치 매뉴얼 - 페이지 3
{카테고리_이름} Jandy AquaLink RS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy AquaLink RS 8 페이지. Battery wireless, portable control panel
Jandy AquaLink RS에 대해서도 마찬가지입니다: 설치 지침 (1 페이지), 설치 지침 (1 페이지), 설치 매뉴얼 (4 페이지)
페이지 인쇄
Power Center Low Voltage Surge Suppression
4-wire RS485 and First Spa Side Switch
Use the Power Center Surge Suppression PCB to protect the Power Center PCB from surges that can enter
from the 4-wire RS485 cable and first Spa Side Switch in the system. All 4-wire cables that enter the Power
Center enclosure must be connected to the Surge Suppression PCB. Voltage signals are then transferred to
the Power Center PCB, see Figure 1.
To Ground Bar in Power Center
(Route through hole in Relay Step)
To Red, 4-pin Terminal Bar
(on Power Center PCB)
To Brown, 6-pin Terminal Bar
(on Power Center PCB)
Figure 1.
Power Center Surge Suppression PCB Wiring Diagram
If using more than one Spa Side Switch, Switch #2 and #3 must first be connected to the Dual Spa Side
Interface PCB (P/N 6588). The Dual Spa Side Interface PCB includes a 4-wire cable that connects to the red
terminal bar on the Surge Suppression PCB (see Figure 5 on back of this manual). Two sets of 4-wire cables
that enter the Power Center can be "doubled up" on the red terminal bar, see Figure 1.
Never connect more than two wires on each of the pins of the red terminal bar. Use the Jandy
Multiplex PCB, p/n 6584, when more than two of the 4-wire cables are used with the system.
Mount Surge Suppression PCB in Daughter Card area of Power Center Bezel, see Figure 2. If all Daughter
Card slots are full, use the stand-off strips provided with the Surge Suppression PCB. Attach a strip on each
side of the PCB, peel off the adhesive backing, and then mount the PCB to the back of the Power Center
Can in the Low Voltage Area.
Power Center
Surge Suppression
PCB (#6941)
Figure 2.
Power Center Bezel
GREEN
YELLOW
BLACK
RED
RED
BLACK
GREEN
WHITE
BROWN
BLUE
CAUTION
Daughter Card Slot in
Power Center Bezel
Mounting Bracket
Page 3
Attach incoming
4-wire cable here.
Attach Spa Side
Switch #1 here.