KitchenAid KEBI276 사용 및 관리 매뉴얼 - 페이지 14
{카테고리_이름} KitchenAid KEBI276에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KEBI276 16 페이지. Kitchenaid built-in electric single and double ovens use & care guide
페이지 인쇄
Oven Door
For normal use, it is not suggested to remove the oven door.
However, if necessary, follow these instructions. The oven door is
heavy.
To Remove:
1. Open the oven door all the way.
2. Insert short end of door removal pins, included with the oven,
into both hinge hangers. Two
two nails of similar diameter can be used if door removal pins
have been misplaced. Do not remove the pins while the door
is removed.
1. Insert small end of pin here
3. Grasp under door handle and carefully close door as far as it
will shut. Pull door out from the bottom.
To Replace:
1. Make sure door removal pins have not been removed. Fit
hinge arms into slots in frame. Push in at lower corner to
ensure hinge arms are fully engaged.
2. Open the door completely and remove the door removal pins.
Save them for future use.
3. Close oven door. If the door does not operate freely, repeat
the process.
14
in. (4 mm) allen wrenches or
1
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Has a household fuse been blown or has the circuit
breaker been tripped?
Replace the fuse or reset the circuit.
Is the appliance wired properly?
See Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
Has a delay start been set?
See "Timed Cooking" section.
On some models, is the Control Lock set?
See "Control Lock" section.
On some models, is the Sabbath Mode set?
See "Sabbath Mode" section.
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning the other oven cannot be set
or turned on.
On double oven models, has the correct oven been
selected?
Choose UPPER OVEN or LOWER OVEN first.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
Display shows messages
Is the display showing "PF", "PF id=27" or "PF id=30"?
There has been a power failure. Clear the display. See
"Display(s)" section. On some models, reset the clock, if
needed. See "Clock" section.
Is the display showing a letter followed by a number?
Clear the display. See "Display(s)" section. If it reappears, call
for service. See "Assistance or Service" section.
Self-Cleaning cycle will not operate
Is the oven door open?
Close the oven door all the way.
Has the function been entered?
See "Self-Cleaning Cycle" section.
On some models, has a delay start Self-Clean cycle been
set?
See "Self-Cleaning Cycle" section.
Has a delay start been set?
See "Timed Cooking" section.
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning, the other oven cannot be set
to self-clean.