HIKVISION DS-3WF Series 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} HIKVISION DS-3WF Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-3WF Series 20 페이지. Wireless bridge

페이지 인쇄
 In the use of the product, you must be in strict compliance with the electrical safety regulations
of the nation and region.
 The socket-outlet shall be installed near the device and shall be easily accessible.
 Do not connect several devices to one power adapter as adapter overload may cause
overheating or a fire hazard.
 If a power adapter is provided in the device package, use the provided adapter only. If no power
adapter is provided, ensure the power adapter or other power supply complies with Limited
Power Source. Refer to the product label for the power supply output parameters.
 Please make sure that the plug is firmly connected to the power socket.
 Do not touch the bare components (such as the metal contacts of the inlets) and wait for at
least 5 minutes, since electricity may still exist after the device is powered off.
 The interface varies with the models. Please refer to the product datasheet for details.
 If the device needs to be wired by yourself, select the corresponding wire to supply power
according to the electric parameters labeled on the device. Strip off wire with a standard wire
stripper at corresponding position. To avoid serious consequences, the length of stripped wire
shall be appropriate, and conductors shall not be exposed.
 Make sure that the power has been disconnected before you wire, install, or disassemble the
device.
 If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
power cable, and contact the service center.
 If the device supports wall mounting or ceiling mounting, the mounting surface shall be able to
withstand the additional force of three times the weight of the device but not less than 50 N.
The device and its associated mounting means shall remain secure during the installation. After
the installation, the device, including any associated mounting plate, shall not be damaged.
Refer to Datasheet for details.
iii