Airgo 700-426 사용자 설명서 - 페이지 9

{카테고리_이름} Airgo 700-426에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airgo 700-426 12 페이지.

Adjusting the swing-away elevating leg rest

(models no. 700-426 and 700-428)

1. To adjust the elevating leg rest, raise legs until the desired height

is obtained.

2. To reposition leg rest to normal position, support leg with one hand

and push release handle downward with the other hand.

3. To adjust the calf pad, turn the pad towards the outside of the wheelchair.

4. Slide the calf pad up or down until the desired position is obtained.

5. To secure the calf pad, turn the calf pad towards the inside of

the wheelchair.

1 4

Adjusting the wheel locks

1. Ensure the wheel-lock is in the open (unlocked) position.

2. Loosen the bolt & locknut that secure the wheel-lock to the

wheelchair frame.

3. Adjust the position of wheel-lock until the measurement between the

rear wheel and the wheellock shoe is between 1/4 and 13/32 inches.

4. Securely tighten the bolt & locknut.

5. Engage the wheel-lock and push against the wheelchair to determine if

wheel-lock engages the wheel-lock shoe enough to hold the wheelchair.

6. Repeat the above procedures until the wheel-lock holds the wheelchair.

PULL TO LOCK

UNLOCKED

POSITION

BOLT & LOCKNUT

WHEEL-LOCK

HANDLE

WHEEL-LOCK

SHOE

1/4" - 13/32"

REAR

(6.4 - 10.3 mm)

WHEEL

TO REMOVE DETACHABLE DESK ARMS (IF APPLICABLE)

1. Push in the button lock at the front base of the arm.

2. Lift the arm up and off.

TO REPLACE DETACHABLE DESK ARMS (IF APPLICABLE)

1. Reposition the arms.

2. The button lock will automatically snap in place.

LOCKED

POSITION

1 5