Brizo Charlotte T60485 설치 지침 및 사용 설명서 - 페이지 6

{카테고리_이름} Brizo Charlotte T60485에 대한 설치 지침 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brizo Charlotte T60485 20 페이지. Valve trim
Brizo Charlotte T60485에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (20 페이지)

페이지 인쇄

60 Series Installation

Installation and Adjustment of the Temperature Knob

Failure to do so may cause injury.

Adjust temperature limit stop. Turn on water

supplies; let the water run at both full hot and

full cold to ensure the water is running as hot/

cold as possible. Place a thermometer in a

plastic tumbler, and hold the tumbler in the water

stream. Place the temperature knob (1) onto the

splines (2), then rotate the temperature knob

until you achieve your maximum desired

temperature from the outlet (not more than 120°

or the lower temperature mandated by your local

60 Series Maintenance

Faucet leaks from showerhead or tub spout:

SHUT OFF WATER SUPPLIES. Replace Cartridge

Assembly –Repair Kit RP47201.

plumbing code). Remove the temperature knob

and replace onto the splines (2), making sure that

the temperature knob limit stop (3) hits against

the volume handle limit stop (4) as shown.

Note: Temperature lever is intended to point

upward near 12 o'clock position. Once desired

position is acquired per instructions above, thread

screw (5) into handle (1) and secure it to valve

stem by tightening screw. Insert button (6) into

screw hole.

If water does not flow:

Verify that the hot side of the cartridge is installed

on the hot water supply line. If it is not, turn off

water supplies and flip cartridge.