AIRGOO AG-60 매뉴얼 - 페이지 2

{카테고리_이름} AIRGOO AG-60에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRGOO AG-60 4 페이지. Pottery wheel with foot pedal

OPERATIONAL WARNING

• Care must be taken when operating your Pottery Wheel. This wheel contains moving

parts that could result in serious injury if not operated correctly. You should always

inspect the wheel prior to use making sure all components are attached correctly.

• Before plugging in your pottery wheel, you should check to make sure power switch is in

the off position. The speed dial should be set to its lowest setting prior to plugging in. If

using the option foot pedal, be sure to unplug pottery wheel first before attaching the foot

pedal.

SPLASH PAN

• This Pottery Wheel contains a 2-part water splash pan that must be assembled on the

machine prior to use. The smaller section of the splash pan goes closest to the pottery

wheel head unit with the LCD. The 2-Pieces should slide under the wheel spindle and

overlap to lock into place

• Do not attempt to remove the splash pan when the unit is running.

BATS

• The Pottery Wheel comes with an 11-1/2" molded plastic bal Each bat has three molded

bat holders that insert into pre drilled holes on the pottery wheel disc. Be sure to properly

secure the bat to the wheel prior to use.

• Bats can be cleaned with soap and water after each use. Do not place in dishwasher

• Additional bats are available.

LCD CONTROLS

1. Turn on Power Switch

2. Press RUN to engage the wheel

3. Press STOP to disengage the wheel

4. Press FWD/REV to change wheel spin direction

5. Turn the speed adjustment knob to control wheel speed.

6 Note: Anytime the STOP button is pressed you must press the RUN button to

re-engage the wheel before it will operate.

HAND CONTROL KNOB

• The Hand Control Knob is located on the front LCD Panel. This knob controls the speed

of the pottery wheel. Turning the knob clockwise will increase the speed and turning the