Gardena 14632 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Gardena 14632에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 14632 14 페이지. Battery lawnmower

페이지 인쇄

4.2 To clean the battery and the battery charger:

The surface and the contacts of the battery and the battery charger must

be clean and dry before the battery is connected to the battery charger.

v Do not use running water.

4.2.1 To clean the battery:

v Occasionally clean the ventilation slots and the terminals on the battery

using a soft brush that is clean and dry.

4.2.2 To clean the battery charger:

v Clean the contacts and the plastic parts with a soft and dry cloth.

5. STORAGE

5.1 To put into storage:

The product must be stored away from children.

(19)

to position 0 and remove it to prevent the battery

1. Turn the safety key

from discharging.

2. Remove the battery.

3. Charge the battery.

(23)

4. Empty the grass catcher box

5. Clean the mower, the battery and the battery charger

(see 4. MAINTENANCE).

6. Store the mower, the battery and the battery charger in a dry, enclosed

and frost-free place.

5.1.1 Storage position to save space [ Fig. S1 ]:

(7)

1. Loosen both wing nuts

2. Fold the upper handlebar

(4)

downwards onto the mower.

Make sure that the cable is not trapped between the upper and lower

handlebar, otherwise the cable may be damaged.

6. TROUBLESHOOTING

DANGER!

Cutting injury due to the blade!

Risk of cut injury due to accidental starting.

v Use gloves.

v Wait for the blade to stop.

v Remove the safety key.

v Remove the batterie.

6.1 To replace the blade [ Fig. T1 / T2 ]:

DANGER!

Risk of physical injury!

Risk of cutting injuries if a damaged or bent knife or one with

unbalanced or chipped cutting edges rotates.

v Do not use the mower when the blade is damaged, bent, out of

balance or has chipped edges.

v Do not regrind the blade.

The GARDENA spare parts are available from your GARDENA dealer

or from the GARDENA service.

v Only use an original GARDENA Replacement blade

For safety reasons, we recommend that the blade be replaced by

GARDENA Service or by an authorised GARDENA dealer.

1. Insert a screwdriver into one of the provided holes

the housing.

The screwdriver thus serves as a stop for the blade.

(29)

2. Unscrew the blade bolt

Make sure that the spacer

(29)

3. Remove the blade bolt

and the washer

Art. 4121

(28)

at the bottom of

is not damaged when applying the force.

4. Remove the blade

32 32

5. Put the new blade

on the mower. The inscription on the knife

32 32

(this side to grass) must be visible.

6. Put the washer

and the blade bolt

7. Screw the new blade

tight with the blade bolt

32 32

15 – 20 Nm). Do not over-torque.

Make sure that the spacer

8. Pull the screwdriver out of the mower.

Make sure that the screwdriver is removed before restarting the mower

again.

6.2 Troubleshooting table:

Problem

Possible Cause

Engine is blocked

Obstacle blocks the motor.

Cutting height is too low.

Loud noises, the mower

Screws on motor, its fixing

is rattling

or on the mower chasing are

loose.

Mower runs unevenly or

Blade is damaged or worn.

vibrates strongly

Blade bolt is released.

Blade is very dirty.

Lawn is not cleanly mowed

Blade is blunt or damaged.

Cutting height is too low.

Mower does not start or

Battery is empty.

stops.

(L1)

LED

blinks green

[ Fig. O4 ]

Mower does not start or

Battery temperature is outside

stops.

the permissible temperature

(Wp)

Error-LED

lights red

range.

[ Fig. O4 ]

There are drops of water or

moisture between the battery

contacts.

Obstacle blocks the motor.

Mower does not start or

Mower is defective

stops.

Error-LED

(Wp)

blinks red

[ Fig. O4 ]

Mower does not start or

Battery is not put completely

stops.

into the battery holder.

Error-LED

(Wp)

does not

light [ Fig. O4 ]

Safety key is not turned to

positon 1.

Battery is defective.

Mower is defective.

Charging is not possible.

Battery is not slid onto the

(Lc)

Battery charge indicator

charger correctly.

lights continuously green

Battery contacts are dirty.

[ Fig. O3 ]

Battery temperature is outside

the permissible temperature

range.

Battery is defective.

Charging is not possible.

Mains plug of the charger is

Battery charge indicator

(Lc)

not plugged in correctly.

does not light

Mains socket, mains cable or

[ Fig. O3 ]

charger is defective.

NOTE:

Repairs must only be done by the GARDENA service departments or

specialist dealers approved by GARDENA.

v For any other malfunctions please contact the GARDENA service

department.

(29)

on the mower.

(29)

(tightening torque is

is not damaged when applying the force.

Remedy

v Remove the obstacle.

v Increase the cutting height.

v Let the screws be tightened

by an authorised specialist

dealer or the GARDENA

Service.

v Replace the blade.

v Tighten the blade bolt.

v Clean the mower. If this does

not solve the problem, con-

tact the GARDENA Service.

v Replace the blade.

v Increase the cutting height.

v Charge the battery.

v Wait until the battery

temperature is between

0 °C – + 45 °C again.

v Remove the water drops or

moisture with a dry cloth.

v Remove the obstacle.

v Contact the GARDENA

Service.

v Put the battery completely

into the battery holder until

it audibly engages.

v Turn the safety key to

position 1.

v Replace the battery.

v Contact the GARDENA

Service.

v Slide the battery onto the

charger correctly.

v Clean the battery contacts

(e. g. by connecting and dis-

connecting the battery several

times. Replace the battery if

necessary.

v Wait until the battery

temperature is between

0 °C – + 45 °C again.

v Replace the battery.

v Insert the mains plug com-

pletely into the mains socket.

v Check the mains voltage.

Let the charger be checked

if necessary by an authorised

specialist dealer or the

GARDENA Service.