Gardena 400 C 사용 설명서 - 페이지 6
{카테고리_이름} Gardena 400 C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 400 C 10 페이지. Hand cylinder lawnmower
Gardena 400 C에 대해서도 마찬가지입니다: 사용 설명서 (10 페이지), 사용 설명서 (7 페이지), 사용 설명서 (10 페이지)
페이지 인쇄
Adjusting the cutting
mechanism:
q
w
e
w
9
r
9
q
ß
Regrinding / repairs:
8. Available accessories
GARDENA Grass Catcher
12
The cutting gear of your cylinder mower was optimally adjusted
before leaving our company. If, after longer use,
a clean cut of the grass is no longer possible or the blade roller
contacts the lower blade, then the lower blade should be
adjusted as follows:
1. Clean the cylinder mower.
2. Lay the mower onto the ground, so that it cannot fall over
when adjusting the cutting mechanism.
3. Check cylinder
these with a grindstone if necessary.
4. Unscrew the left and right hexagon screws
e
wrench (10 mm) anticlockwise until the blade cylinder
only just turn freely.
5. Carefully tighten the left hexagon screw
wrench (10 mm) whilst the blade cylinder
lightly contacts the lower blade
6. Then unscrew the left hexagon screw again until the blade
cylinder just stops contacting the lower blade (rotates sound-
lessly).
7. Repeat the process on the right-hand side.
8. Cutting test:
Place a strip of paper
that it points towards the spindle of the cylinder
9. Turn cylinder
If the lower blade is set correctly
if with scissors.
10. Repeat the cutting test at different positions and on all blades
on the blade cylinder
On safety grounds, only original GARDENA spares
may be used.
Please contact GARDENA Service if it is necessary to replace
the cutting tool, which will only become blunt after several years
use if well-maintained. Repairs to the cylinder mower and the
installation of the blades can be undertaken by suitable specialist
workshops.
Have the cylinder mower checked over in the autumn if possible
so that it is ready for use immediately when the next lawn-mowing
season starts.
For any other malfunctions please contact the GARDENA service
department.
Saves raking up the cut grass.
and lower blade
q
w
.
w
in such a way on the lower blade
r
carefully.
q
the paper will be cut off as
w
.
q
for notches and remove
using a hexagon
e
can
q
using a hexagon
e
rotates, until it
q
w
.
q
Art. No. 4029