KitchenAid KEMS308SWH02 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} KitchenAid KEMS308SWH02에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KEMS308SWH02 12 페이지. 27" (68.6 cm) and 30" (76.2 cm) electric built-in microwave/oven combination
KitchenAid KEMS308SWH02에 대해서도 마찬가지입니다: 부품 목록 (11 페이지)

KitchenAid KEMS308SWH02 설치 지침 매뉴얼
Cabinet Dimensions
27" (68.6 cm) and 30" (76.2 cm) Ovens
_A_
T
E
_.D_
27" (68.6 cm) models
A. 27" (66.6 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 19¼" (48.9 cm) bottom of
cutout to floor
D. 25½" (64.6 cm) cutout width
E. 1½" (3.6 cm) rain. bottom of
cutout to top of cabinet door
F. 4! ¼" (104.8 cm) cutout height
B
+
C
30" ('76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout te
bottom of upper cabinet door
C. 19¼" (46.9 cm) bottom of
cutout to floor
D. 26½" (72.4 cm) cutout width
E. ! ½" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 41 ¼" (104.3 cm) cutout height
Cabinet
Side View
_B
_
f
E_
/C
D
A. 23 ¼" (59.1 cm) min. cutout depth
B. 23" (58.4 cm) recessed oven depth
C. Oven front
D. Recessed oven
E. Cabinet
If codes permit and a separate ground wire is used, it is
recommended
that a qualified electrical installer determine that
the ground path and wire gauge are in accordance
with local
codes.
Check with a qualified electrical installer if you are not sure the
oven is properly grounded.
This oven must be connected to a grounded metal, permanent
wiring system.
Be sure that the electrical connection and wire size are adequate
and in conformance
with the National Electrical Code, ANSI/
NFPA 70-latest edition or CSA Standards C22.1-94, Canadian
Electrical Code, Part 1 and C22.2 No. O-M91-1atest edition, and
all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch
Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical
Connection
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
Oven must be connected to the proper electrical voltage and
frequency as specified on the model/serial
number rating
plate. The model/serial
number rating plate is located at the
bottom of the right-hand mounting rail. See the following
illustration.
A. Model/serial
number plate
Models rated from 7.3 to 9.6 kW at 240 volts (5.5 to 7.2 kW
at 208 volts) require a separate 40-amp circuit. Models rated
at 7.2 kW and below at 240 volts (5.4 kW and below at
208 volts) require a separate 30-amp circuit.
A time-delay fuse or circuit breaker is recommended.
Connect directly to the fused disconnect
(or circuit breaker
box) through flexible, armored or nonmetallic
sheathed,
copper cable (with grounding wire). See "Make Electrical
Connection"
section.