Gardena 4051 사용 설명서 - 페이지 7

{카테고리_이름} Gardena 4051에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4051 12 페이지. Petrol lawnmower

페이지 인쇄

Only original GARDENA Blade Bars with original fixing must

be used. Spare GARDENA parts can be obtained from your

GARDENA dealer or the GARDENA service department.

• 46 V / 46 VD / 46 VDA:

• 51 VDA:

Fault

Possible cause

Engine does not start.

Petrol tank empty.

Wrong engine setting.

Spark plug connector not

inserted / spark plug faulty.

Cutting height too low for the

lawn or mowing speed too high.

Motor does not start.

Bowden cable of the switch

handle has moved due to wear.

After an initial warm-up

Too much oil in the motor,

phase, the motor starts only

spark plug is coked

with difficulty or not at all.

by excessive oil quantity.

Drive does not start.

Bowden cable of the drive has

moved due to wear.

No motor oil in crankcase.

Engine runs for a short time

but then suddenly stops with

Piston and crankshaft bearings

a loud bang.

have jammed.

A lot of engine smoke after

Oil in the exhaust because

starting.

the mowr has been tipped

sideways.

Loud noises, mower rattling.

Screws on motor, its fixing or on

the mower casing loose.

Runs unevenly,

Blade Bar damage or blade

mower vibrates strongly.

fixing on the engine shaft has

come loose.

Imbalance resulting from very

dirty blade bar.

GARDENA Blade Bar

Art. 531211017

GARDENA Blade Bar

Art. 504113301

Remedy

v Fill with petrol.

v See 5. Operation "Starting the

mower with a warm engine".

v Insert spark plug connector/

clean or replace spark plug

(Champion RJ 19 LM

Art. 4012-00.901.01).

v Raise cutting height or

reduce mowing speed.

v Adjust Bowden cable of the

switch handle.

v Release excessive oil

following the instructions

for the motor and clean

the spark plug.

v Adjust Bowden cable of the

drive.

v Have the engine serviced

by GARDENA Service.

v Let the engine run for

about 3 min. until the oil

has evaporated.

v Have screws tightened by an

authorised specialist dealer

or GARDENA Service.

v Have the blade bar

tightened again or replaced

by an authorised dealer

or GARDENA Service.

v Clean mower

(see 7. Maintenance).

If this does not rectify the

fault, contact GARDENA

Service.

Fault

Possible cause

Lawn is not cleanly cut.

Blade bar blunt.

Cutting height too low for the

lawn or mowing speed too high.

For any other malfunctions please contact the GARDENA service department.

Repairs must only be carried out by GARDENA service departments or specialist

dealers authorised by GARDENA.

9. Technical Data

46 V

(Art. 4044)

Engine (cubic capacity)

Briggs & Stratton

450

(148 cm

)

Wheel drive

–

SAE 30 (0,6 l)

Engine oil (tank volume)

Petrol

unleaded petrol

(min. 87 octane)

Cutting width

46 cm

Cutting height

30 / 40 / 50 /

60 / 70 / 80 mm

Height adjustment

central 6 x

Wheel sizes

190 / 210 mm

Wheel bearing

ball bearing

incl. unit

Mulch function

Collection Bag volume

53 l

Weight

29,9 kg

For lawn areas

up to approx. 500 m

Water connection (cleaning)

Original GARDENA hose connection system

Working area related emission

84 dB (A)

characteristic value L

Noise level L

measured 95 dB (A) measured 95 dB (A) measured 95 dB (A) measured 97 dB (A)

measured / guaranteed

guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 98 dB (A)

Vibrations a

< 5,0 m/s

vhw

Measuring method

EN 836

2000/14/EG

Remedy

v Have the blade bar replaced.

v Raise cutting height or

reduce mowing speed.

46 VD

46 VDA

51 VDA

(Art. 4046)

(Art. 4047)

(Art. 4051)

Briggs & Stratton

550

675 ready start

(158 cm

)

(190 cm

)

(190 cm

)

1 gear rear wheel

variable rear wheel variable rear wheel

SAE 30 (0,6 l)

unleaded petrol

(min. 87 octane)

46 cm

51 cm

30 / 40 / 50 /

25 / 35 / 45 /

25 / 35 / 45 / 65 /

60 / 70 / 80 mm

65 / 75 / 95 mm

75 / 95 mm

central 6 x

190 / 210 mm

190 / 280 mm

ball bearing

incl. unit

53 l

60 l

32,1 kg

34,3 kg

37,5 kg

up to approx. 800 m

up to approx. 1000 m

84 dB (A)

< 5,0 m/s