Gardena 4054-60 빠른 매뉴얼 - 페이지 3
{카테고리_이름} Gardena 4054-60에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4054-60 4 페이지.
페이지 인쇄
3. Connecting the boundary wire
See chapter 3.4.2 in the supplied operator's manual or on the
GARDENA website (www.gardena.com).
1. Open the connector and lay the boundary wire in the connector.
2. Press the connector and the wire together by using a pair of pliers.
3. Cut off the wire 1 to 2 cm after the connectors.
4. Press the boundary wire connectors onto the contact pins marked L (left) and R (right)
on the charging station.
NOTE: The right-hand wire must be connected to the right-hand contact pin on the
charging station, and the left-hand wire to the left-hand pin.
4. Laying and connecting the guide wire
See chapter 3.3.4 and 3.4.3 in the supplied operator's manual or on the
GARDENA website (www.gardena.com).
1. Fasten the guide wire in snap locks at the bottom of the charging station.
2. Fit the connector to the guide wire in the same way as for the boundary wire,
according to the instructions above.
3. Press the guide wire connector onto the contact pin marked Guide on the charging
station.
4. Pull the guide wire a minimum of 1 meter straight out from the front edge of the
charging station.
5. Lay the guide wire from the charging station to the point on the boundary wire
(eyelet) where the connection is made.
NOTE: Do not lay the guide wire at an acute angle.
6. Cut the boundary wire at the centre of the eyelet that was made in step 2.2.
7. Connect the guide wire to the boundary wire by inserting the boundary wires and
guide wire in the coupler, and pressing the coupler together with a multi-grip
pliers.
„As a complement to this Quick Guide. There are step by step
installation movies available on the GARDENA website,
www.gardena.com."
Power supply
(the appearance of the power supply
may differ depending on market)
P01_P02_QG_USEN.indd 3
Low voltage cable
Boundary wire and
couplers
2
1
4
5
7
Pegs
Connectors
3
1
min 1 m / 3.3 ft
4
Measurement
gauge
2019-02-06 14:50:03