Gardena 4066 사용 설명서 - 페이지 6

{카테고리_이름} Gardena 4066에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4066 12 페이지. Electric lawn rake
Gardena 4066에 대해서도 마찬가지입니다: 사용 설명서 (9 페이지), 운영자 매뉴얼 (15 페이지), 운영자 매뉴얼 (15 페이지), 운영자 매뉴얼 (15 페이지), 운영자 매뉴얼 (9 페이지), 운영자 매뉴얼 (9 페이지)

페이지 인쇄

6. Maintenance

Cleaning Lawn Scarifier:

Adjusting for wear :

Blockage Protection : If the aerator cylinder is blocked, e.g.

by a foreign body, immediately release the starting lever. If the

blockage lasts longer than 10 seconds and the starting lever has

not been released, blockage protection is activated. In this case

immediately release the starting lever. The Lawn Scarifier can

be switched on again after cooling down for approx. 1 minute.

Danger of injury !

If blockage protection is activated and the starting

lever is not released, the Lawn Scarifier starts again

automatically after approx. 1 minute.

Danger ! The aerator cylinder can cause injuries !

V Prior to maintenance, unplug from the mains and

wait until the Scarifier drum has stopped.

V Wear working gloves for performing maintenance.

The Lawn Scarifier should be cleaned after each time it is used.

Risk of injury and physical damage !

V Do not clean Lawn Scarifier under running water

(particularly under high pressure).

V Do not use hard or pointed objects for cleaning

the Lawn Scarifier.

v Remove grass and deposits from wheels, aerator cylinder

and housing.

The Lawn Scarifier is subject to wear in use due to the way in

which it works. The more intensively the Lawn Scarifier is used,

the greater the wear on the spring tines.

Hard or very dry ground accelerates wear as does excessive use

of the Lawn Scarifier.

If the results of your work with the Lawn Scarifier become increas-

ingly worse due to wear of the spring tines, the aerator cylinder

can be adjusted twice.

The aerator cylinder has 4 adjustment positions :

• Transport position

• Aerating position 1 :

• Aerating position 2 :

If the springs are worn (the scarifier roller is lowered by 3 mm).

• Setting 3 :

Second setting for worn springs (the scarifier roller is lowered

by a further 3 mm).

Push wear compensation lever

and move to the position required.

Note : Wear adjustment is not used for height adjustment.

Adjustment of the aerator cylinder without visible wear can

cause damage to the aerator cylinder or overload the motor.

gently away from the housing