Gardena 4066 운영자 매뉴얼 - 페이지 5

{카테고리_이름} Gardena 4066에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4066 15 페이지. Electric lawn rake
Gardena 4066에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지), 사용 설명서 (9 페이지), 운영자 매뉴얼 (15 페이지), 운영자 매뉴얼 (15 페이지), 운영자 매뉴얼 (9 페이지), 운영자 매뉴얼 (9 페이지)

페이지 인쇄
Gardena 4066 운영자 매뉴얼

4. Assembly

Assembling the handle:
8
4
c
2
5
v First of all, mow your lawn to the length you require.
We particularly recommend this if the grass has grown tall
(e.g. while you were away on holiday).
Recommendation: the shorter you mow your lawn, the easier
it is to aerate, thus lessening the strain on the Electric Lawn
Rake and increasing the lifetime of the aerator cylinder.
Remaining in one spot too long, or aerating if the ground is wet or
too dry can damage the grass.
v For good results, guide the Electric Lawn Rake at an
appropriate speed in strips as straight as possible across
your lawn.
To avoid leaving any gaps during aerating, the strips should
touch.
v Always guide the Electric Lawn Rake at an even speed
depending on the type of ground.
v When working on inclines always stand diagonally to the
incline in a sturdy, safe stance. Do not work on extremely
steep slopes.
Danger of tripping!
To prevent tripping take particular care when moving
backwards and when pulling the Electric Lawn Rake.
When aerating areas of very mossy lawn we recommend resowing
the lawn after aerating. This helps the areas of lawn which were
replaced by moss to regenerate more quickly.
v Do not place the connecting cable
1. Insert the two lower sections of the upright
7
with the round hole) in the mountings in the motor casing
and secure with the crosshead screws
3
2. Insert the two locking bolts
in the two central sections
lower sections of the upright
3. Screw the upper part of the upright with starting handle
1
the central sections of the upright
bolts
1
This completes the assembly of the handle.
6
Warning: Fit the upper section of the upright with starting
handle
cable
8
9
(see fig.).
4. Attach connection cable
clips
c
during assembly.
1
2
5
and the wing nuts
.
4
in such a way that the plug
3
is on the right side (in direction of movement)
to the handle with the two cable
8
.
under strain
8
(with the end
5
.
9
from outside through the holes
of the upright and secure to the
with two wing nuts
4
with two more locking
2
with the power
7
6
.
to
3
15