Gardena 5041-20 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Gardena 5041-20에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 5041-20 10 페이지. Battery lawnmower
Gardena 5041-20에 대해서도 마찬가지입니다: 운영자 매뉴얼 (17 페이지), 운영자 매뉴얼 (10 페이지)

페이지 인쇄
Gardena 5041-20 운영자 매뉴얼
To clean the underside of the product [ Fig. M1 ]:
The underside is easiest to clean after you mowed.
Use gloves.
1. Lay the product on its side carefully.
2. Clean the underside, the blade and the airflow slots
(do not use sharp objects).
To clean the overside of the product and the grass box:
1. Clean the overside with a damp cloth.
2. Clean the airflow slots and the grass box with a soft brush
(do not use sharp objects).
To clean the battery and the battery charger:
Make sure that the surface and the contacts of the battery and the battery
charger always are clean and dry before you connect the battery charger.
Do not use running water.
v Clean the contacts and the plastic parts with a soft and dry cloth.
5. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Turn the safety key to position 0 and remove it.
2. Remove the battery.
3. Charge the battery.
4. Clean the product, the battery and the battery charger
(see 4. MAINTENANCE).
5. To save space, release the wing nuts of the handles until the joints can
be folded together easily. Make sure that the cable is stowed correctly
to prevent damage.
6. Stow the product, the battery and the charger in a dry, enclosed and
secure place and in a frost-free place before the first frost arrives.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
Disposal of the battery:
The GARDENA battery contains lithium-ion cells that should not
be disposed of with normal household waste at the end of its life.
IMPORTANT!
v Dispose of the batteries through or via your municipal recycling
collection centre.
1. Discharge the lithium-ion cells completely (contact the GARDENA
Service).
2. Protect the contacts on the lithium-ion cells against short circuits.
3. Dispose of the lithium-ion cells properly.

6. TROUBLESHOOTING

DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you do troubleshooting.
To replace the blade:
DANGER! Risk of injury!
Cut injury when the blade turns and it is damaged, bent,
out of balance or has chipped edges.
v Do not use the product when the blade is damaged, bent, out
of balance or has chipped edges.
v Do not regrind the blade.
12
The GARDENA spare parts are availible from your GARDENA dealer or
from the GARDENA service.
Only use an original GARDENA blade:
– GARDENA replacement blade Art. 4104.
v Let the blade replace by the GARDENA Service or a specialist dealer
(19)
with a brush
authorised by GARDENA .
Problem
Engine does not start
Engine is jammed and
makes a noise
Loud noises, the mower
is rattling
Product runs unevenly
or vibrates strongly
Lawn is not cleanly cut
ç
Error-LED
lit [ Fig. O3 ]
¥
Error-LED
flashes [ Fig. O2 ]
¥
Error-LED
illuminates [ Fig. O2 ]
Charging control lamp
on the charger does not
illuminate [ Fig. O1 ]
Charging control lamp
the charger flashes rapidly
(4 times per second) [ Fig. O1 ]
≈
Error-LED
flashes [ Fig. O1 ]
≈
Error-LED
illuminates [ Fig. O1 ]
Li-ion

7. TECHNICAL DATA

Battery Lawnmower
Speed of rotation cutting
blade
Cutting width
Cutting height adjustment
(10 positions)
Volume of grass box
Weight
Sound pressure level L
Uncertainty k
Sound power level L
measured/guaranteed
Uncertainty k
Hand/arm vibration a
Uncertainty k
Measuring process complying with:
sure. The vibration emission value can vary during actual use of the electric power tool.
Possible Cause
Blade is blocked.
Blade is blocked.
Cutting height is too low.
Screws on engine, its fixing
or on the mower chasing are
loose.
Blade is damaged or the blade
mounting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
on the panel
Blade is blocked.
Motor overload / Controller
temperature is out of range.
on the battery
Under voltage.
Battery temperature is out of
range.
on the battery
Battery error / battery defective. v Contact the GARDENA
(Lc)
Battery charger or charging
cable are not connected
correctly.
(Lc)
on
Battery temperature is out of
range.
on the charger
Battery error.
on the charger
Temperature inside the
charger is too high.
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.
Unit
Value (Art. 5041)
R/min
3,100
cm
41
mm
25 to 75
l
50
kg
20.6
83
1)
dB (A)
pA
3.0
pA
:
2)
WA
88 / 89
dB (A)
0.5
WA
2.0
1)
m/s
vhw
2
1.5
a
EN 60335­2­77
RL 2000/14/EC
1)
2)
NOTE: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of expo-
Remedy
v Remove the obstacle.
v Remove the obstacle.
v Raise the cutting height.
v Have screws tightened by an
authorised specialist dealer
or the GARDENA Service.
v Have blade tightened or
replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower
(see 4. MAINTENANCE).
If this does not rectify
the problem, contact the
GARDENA Service.
v Have blade replaced by the
GARDENA Service.
v Raise the cutting height.
v Remove the obstacle.
v Let the controller cool down.
v Charge the battery.
v Use the battery in surround­
ings where temperatures are
between 0 °C and 40 °C.
Service.
v Connect the battery charger
and charging cable correctly.
v Use the battery in surround­
ings where temperatures are
between 0 °C and 40 °C.
v Remove the battery and
check that you use an
original GARDENA battery.
v Contact the GARDENA
service.