Gardena 51 VDA 사용 설명서 - 페이지 7

{카테고리_이름} Gardena 51 VDA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 51 VDA 12 페이지. Petrol lawnmower
Gardena 51 VDA에 대해서도 마찬가지입니다: 사용 설명서 및 소유자 매뉴얼 (9 페이지), 사용 설명서 (11 페이지)

Gardena 51 VDA 사용 설명서
Only original GARDENA Blade Bars with original fixing must
be used. Spare GARDENA parts can be obtained from your
GARDENA dealer or the GARDENA service department.
• 46 V / 46 VD / 46 VDA:
• 51 VDA:
Fault
Possible cause
Engine does not start.
Petrol tank empty.
Wrong engine setting.
Spark plug connector not
inserted / spark plug faulty.
Cutting height too low for the
lawn or mowing speed too high.
Motor does not start.
Bowden cable of the switch
handle has moved due to wear.
After an initial warm-up
Too much oil in the motor,
phase, the motor starts only
spark plug is coked
with difficulty or not at all.
by excessive oil quantity.
Drive does not start.
Bowden cable of the drive has
moved due to wear.
No motor oil in crankcase.
Engine runs for a short time
but then suddenly stops with
Piston and crankshaft bearings
a loud bang.
have jammed.
A lot of engine smoke after
Oil in the exhaust because
starting.
the mowr has been tipped
sideways.
Loud noises, mower rattling.
Screws on motor, its fixing or on
the mower casing loose.
Runs unevenly,
Blade Bar damage or blade
mower vibrates strongly.
fixing on the engine shaft has
come loose.
Imbalance resulting from very
dirty blade bar.
26
GARDENA Blade Bar
Art. 531211017
GARDENA Blade Bar
Art. 504113301
Remedy
v Fill with petrol.
v See 5. Operation "Starting the
mower with a warm engine".
v Insert spark plug connector/
clean or replace spark plug
(Champion RJ 19 LM
Art. 4012-00.901.01).
v Raise cutting height or
reduce mowing speed.
v Adjust Bowden cable of the
switch handle.
v Release excessive oil
following the instructions
for the motor and clean
the spark plug.
v Adjust Bowden cable of the
drive.
v Have the engine serviced
by GARDENA Service.
v Let the engine run for
about 3 min. until the oil
has evaporated.
v Have screws tightened by an
authorised specialist dealer
or GARDENA Service.
v Have the blade bar
tightened again or replaced
by an authorised dealer
or GARDENA Service.
v Clean mower
(see 7. Maintenance).
If this does not rectify the
fault, contact GARDENA
Service.
Fault
Possible cause
Lawn is not cleanly cut.
Blade bar blunt.
Cutting height too low for the
lawn or mowing speed too high.
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.

9. Technical Data

46 V
(Art. 4044)
Engine (cubic capacity)
Briggs & Stratton
450
3
(148 cm
)
Wheel drive
SAE 30 (0,6 l)
Engine oil (tank volume)
Petrol
unleaded petrol
(min. 87 octane)
Cutting width
46 cm
Cutting height
30 / 40 / 50 /
60 / 70 / 80 mm
Height adjustment
central 6 x
Wheel sizes
190 / 210 mm
Wheel bearing
ball bearing
incl. unit
Mulch function
Collection Bag volume
53 l
Weight
29,9 kg
For lawn areas
up to approx. 500 m
Water connection (cleaning)
Original GARDENA hose connection system
Working area related emission
84 dB (A)
1)
characteristic value L
PA
2)
Noise level L
measured 95 dB (A) measured 95 dB (A) measured 95 dB (A) measured 97 dB (A)
WA
measured / guaranteed
guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 96 dB (A) guaranteed 98 dB (A)
2
1)
Vibrations a
< 5,0 m/s
vhw
Measuring method
1)
EN 836
2)
2000/14/EG
Remedy
v Have the blade bar replaced.
v Raise cutting height or
reduce mowing speed.
46 VD
46 VDA
51 VDA
(Art. 4046)
(Art. 4047)
(Art. 4051)
Briggs & Stratton
Briggs & Stratton
Briggs & Stratton
550
675 ready start
675 ready start
3
3
3
(158 cm
)
(190 cm
)
(190 cm
)
1 gear rear wheel
variable rear wheel variable rear wheel
SAE 30 (0,6 l)
SAE 30 (0,6 l)
SAE 30 (0,6 l)
unleaded petrol
unleaded petrol
unleaded petrol
(min. 87 octane)
(min. 87 octane)
(min. 87 octane)
46 cm
46 cm
51 cm
30 / 40 / 50 /
25 / 35 / 45 /
25 / 35 / 45 / 65 /
60 / 70 / 80 mm
65 / 75 / 95 mm
75 / 95 mm
central 6 x
central 6 x
central 6 x
190 / 210 mm
190 / 280 mm
190 / 280 mm
ball bearing
ball bearing
ball bearing
incl. unit
incl. unit
incl. unit
53 l
53 l
60 l
32,1 kg
34,3 kg
37,5 kg
2
2
2
up to approx. 800 m
up to approx. 800 m
up to approx. 1000 m
84 dB (A)
84 dB (A)
84 dB (A)
2
2
2
< 5,0 m/s
< 5,0 m/s
< 5,0 m/s
2
27