Gardena PowerMax Li-40/41 운영자 매뉴얼 - 페이지 10
{카테고리_이름} Gardena PowerMax Li-40/41에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena PowerMax Li-40/41 17 페이지. Battery lawnmower
Gardena PowerMax Li-40/41에 대해서도 마찬가지입니다: 운영자 매뉴얼 (17 페이지), 운영자 매뉴얼 (10 페이지), 운영자 매뉴얼 (10 페이지)
페이지 인쇄
To replace the blade:
Troubleshooting table:
Problem
Engine does not start
Engine is jammed and
makes a noise
Loud noises, the mower
is rattling
Product runs unevenly or
vibrates strongly
Lawn is not cleanly cut
ß
Error-LED
on the battery
W
is flashing
ß
Error-LED
on the battery lit
W
ß
Error-LED
on the panel lit
W2
Charging control lamp
does not light up
WARNING! Risk of physical injury!
Cut injury when the blade turns and it is damaged,
bent, out of balance or has chipped edges.
v Do not use the product when the blade is damaged, bent,
out of balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are availible from your GARDENA dealer
or from the GARDENA service.
Only use an original GARDENA blade:
• GARDENA replacement blade Art. 4104.
1. Let the blade replace by the GARDENA Service or a specialist
dealer authorised by GARDENA .
Possible Cause
Blade is blocked.
Blade is blocked.
Cutting height is too low.
Screws on engine, its fixing or
on the mower chasing are loose.
Blade is damaged or the blade
mounting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
Over voltage.
Under voltage.
Battery temperature is out of
range.
Battery error / battery defective.
Blade is blocked.
Motor overload / Controller
temperature is out of range.
t
Battery charger or charging cable
are not connected correctly.
Remedy
v Remove the obstacle.
v Remove the obstacle.
v Raise the cutting height.
v Have screws tightened by
an authorised specialist dealer
or the GARDENA Service.
v Have blade tightened or
replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower (see 4. MAIN-
TENANCE). If this does not
rectify the problem, contact the
GARDENA Service.
v Have blade replaced by the
GARDENA Service.
v Raise the cutting height.
v Remove the battery and
check that the mains voltage
is correct.
v Charge the battery.
v Use the battery in surroundings
where temperatures are
between – 10 °C and 40 °C.
v Contact the GARDENA service.
v Remove the obstacle.
v Let the controller cool down.
v Connect the battery charger
and charging cable correctly.
23