KitchenAid KOCE500E 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} KitchenAid KOCE500E에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KOCE500E 16 페이지. 27 inch (68.6 cm) and 30 inch (76.2 cm) electric built-in microwave/oven combination
KitchenAid KOCE500E에 대해서도 마찬가지입니다: 설치 지침 (1 페이지)

페이지 인쇄

4. Partially close the door to engage the door latch locks. The

door will stop at this point.

5. Using two hands, grasp the edges of the oven door. Lift and

pull the oven door toward you and remove. You may need to

gently shift door from side to side as you pull.

6. Set the oven door(s) aside on the prepared covered work

surface, with the oven door resting on its handle.

7. To continue with the oven installation, go to the "Make

Electrical Connection" section.

Replace Oven Door(s)

IMPORTANT: Do not replace the oven door(s) until after the oven

has been installed into the cabinet.

1. Using two hands, grasp side edges of door at the midpoint.

Face the oven cavity.

2. Locate the slots on each side of the oven cavity for the door

hinge locks.

A. Slot in the oven cavity for door hinge lock

3. At a 45° angle, align door hinges with slots in the lower front

of the oven cavity. Slowly insert door, making sure you

maintain the 45° angle. You will know the door is engaged in

the slot when you feel a slight drop.

4. Lower the oven door to the fully open position. If the oven

door does not open to a full 90°, repeat steps 1 through 3.

5. Locate the oven door hinge locks in the corners of the oven

door, and rotate the hinge locks toward the oven cavity to the

locked position.

See Step 3 (illustration A) in the "Remove Oven Door(s)"

section for proper locked position.

6. Close the oven door.

7. When the hinges are properly installed and the door closed,

there should be an even gap between the door and the

control panel. If one side of the oven door is hanging lower

than the other, the hinge on that side is not properly installed.