KitchenAid Oven 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} KitchenAid Oven에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Oven 13 페이지. Electric built-in 24” and 27” thermal single and double ovens 24” and 27” thermal convection single and double ovens
KitchenAid Oven에 대해서도 마찬가지입니다: 설치 지침 (7 페이지)

Installation

WARNING
Excessive Weight Hazard
Use two or more people to move and
install oven.
Failure to do so can result in back or
other injury.
Important: Use both hands to remove oven
drawer.
Do Not use handle or drawer slides for
lifting.
1.
Turn power supply off. Move oven
close to final position.
• Remove and discard shipping materials,
tape and protective film from the oven.
• Remove and set aside racks and other
parts from inside oven.
2.
Remove the drawer:
• Pull drawer to its full open position.
• Press tab down on right and lift tab
upward on left, then slide drawer out
about 1 inch.
• Carefully remove the drawer from the
slides holding on to the sides, not the
drawer front.
• Set drawer aside on protected surface.
3.
Carefully support the oven in front
of the cutout. Make sure the power to the
outlet is turned off and that the warming
oven power switch is set to the "OFF"
position.
• Plug the power supply cord into the
grounded outlet.
• Slide the oven into the cutout.
• Carefully push against the seal area of
the oven front frame and slide the oven
completely into the cabinet until the
front frame is positioned flush against
the cabinet face.
2 screws
4.
Use two (2) screws provided to
secure the warming oven frame to the
cabinet.
5.
Replace the drawer:
receiving slides
• Align the drawer guides with the
receiving slides.
• Push drawer in completely. Gently open
and close drawer to ensure it is seated
properly on the slides.
6.
Refer to the "Use and Care
Guide," turn the oven on and check the
oven's operation.
5