Gardena 18000 SP Inox 사용 설명서 - 페이지 4

{카테고리_이름} Gardena 18000 SP Inox에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 18000 SP Inox 11 페이지.

페이지 인쇄

Note on

10000 SL Inox

Thermal motor protector

Automatic deaerating valve

3. Initial Operation

Hose diameter

for 10000 SL Inox :

Hose diameter

for 18000 SP Inox :

Hose connection

of universal fitting

Hose connection

For 10000 SL Inox :

Sand and other abrasive substances cause increased wear and

reduce the pump's output.

Take care that the pump is located where the inlet openings at

the suction base are obstructed neither completely nor partly.

Stand the pump on a brick if using in a pond.

When you purchase your pump the swivel feet are set to the

flat suction position (1 mm).

v For normal operation, turn the feet 180° to 5 mm.

The pump is lifted 5 mm.

v Clear the outlet line before use.

The pump is automatically switched off on overheating by

the built-in thermal motor protector. After having cooled down,

the motor automatically switches on again (see 6. Trouble

Shooting).

The automatic deaerating valve eliminates any air pockets in

the pump. Air escapes by the vent bores

form under water. This is not a defect of your pump, but serves

to deaerate the pump.

It may take several seconds for the air to escape when the

pump is immersed for the first time.

13 mm (1/ 2 ")

15 mm (5 / 8 ")

19 mm (3 /4")

–

Cut off topmost

nipple at

The following connection kits are required for 13 mm to

19 mm connections:

13 mm (1/ 2 "): GARDENA Pump Connection Set, Art. No. 1750

25 mm (1")

38 mm (1 1/ 2 ")

Do not cut off

any nipples.

or GARDENA Tap Connector, Art. No. (2)902,

and GARDENA Standard Hose Connector,

Art. No. (2)915

and air bubbles

38 mm (1 1/ 2 ")

50 mm (2 ")

Cut off top two

nipples at