Gardena 3000/4 Jet 사용 설명서 - 페이지 3

{카테고리_이름} Gardena 3000/4 Jet에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 3000/4 Jet 12 페이지. Garden pump
Gardena 3000/4 Jet에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (16 페이지)

페이지 인쇄

2. Safety Instructions

DANGER ! Electric shock !

Risk of injury due to electric shock.

➔ Always unplug your Garden Pump before

filling, after operation, when trouble-

shooting and before carrying out any

maintenance work.

RISK OF INJURY!

Hot water – risk of scalding !

If the pump is operated for prolonged peri-

ods of time (> 5 min) with the delivery side

closed, the water in the pump may heat up

so that there is a risk of scalding yourself

with hot water.

➔ The pump should not run against the

closed delivery side for more than

5 minutes.

➔ If liquid fails to flow, switch off the pump

immediately.

Location

Caution: Pursuant to DIN VDE 0100-702 and

0100-738 use of the pump nearby swimming

pools and garden ponds and other similar pla-

ces is only permissible if the pump is operated

via a residual-current device (FI switch) with a

residual current rating of m 30 mA. The pump

must not be operated when there are persons

in the swimming pool or garden pond.The

pump must be located on solid, even ground,

protected from flooding. Take care that the

pump cannot fall into water. Position the pump

at a safe distance (min. 2 m) from the liquid to

be pumped. As an additional safety device an

authorised safety switch can be used.

➔ Please ask your electrician for his advice.

When connecting the pump to the water sup-

ply system, the country-specific sanitary regu-

lations must be observed to prevent water not

of drinking water quality being drawn back in.

➔ Please consult a specialist for sanitary

installations.

Extension cables

Date indicated on the type plate must match

technical data of the mains supply.

Pursuant to DIN VDE 0620, power cable as

well as extension cables must not have a

smaller diameter than rubber sheathed cables

described with letter symbols H05 RNF.

➔ Don't use the power cable for carrying the

pump or for plugging off.

In Austria

In Austria, the electrical connections must be

made according to ÖVE-EM 42, T2

(2000)/1979 § 22 based on § 2022. Pursuant

to this regulation it's imperative to operate

pumps for swimming pools and garden ponds

exclusively via an isolating transformer.

➔ Please ask your electrician.

In Switzerland

In Switzerland mobile appliances which are

used outdoors, must be connected via a resi-

dual-current device.

Visual check

➔ Before operating the pump, first make a

visual cheek, if there is any damage of the

pump (esp. regarding power cable and

plug).

A damaged pump must not be used.

➔ In case of damage, please have the pump

checked by our GARDENA Service Centre

or by an authorised electrician.

Note

➔ Protect the pump from rain. Don't use the

pump in wet or moist area

In order to avoid dry-running of the pump,

take care that the end of the suction hose is

always submerged into the liquid.

➔ Before each operation, fill the pump to

overflowing with approx. 2 to 3 l of the

liquid to be pumped!

Sand and other abrasive substances in the

liquid cause in-creased wear and reduce the

pump's output.

➔ Use a pump preliminary filter for pumping

sandy liquids.

Pumping dirty water, e.g. stones, pine needles

etc., can cause damage to the pump.

➔ Do not pump dirty water.

The minimum flow rate is 80 l/h (= 1.3 l/min).

Watering accessories with lower rate must not

be operated.