Gardena 4000/2 automatic 1742 사용 설명서 - 페이지 3

{카테고리_이름} Gardena 4000/2 automatic 1742에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4000/2 automatic 1742 9 페이지. Rain water tank pump
Gardena 4000/2 automatic 1742에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지), 운영자 매뉴얼 (10 페이지), 사용 설명서 (9 페이지), 운영자 매뉴얼 (10 페이지)

페이지 인쇄

Ensure that the electrical connections for

plugs and sockets are made in areas safe

from flooding.

Protect the mains plug and the mains

power cable from heat, oil and sharp

edges.

Observe the mains voltage. The information on

the nameplate must be in agreement with the

data for the mains power grid.

The pump's mains plug must be disconnected

before anybody enters the swimming pool.

Do not interrupt the mains supply by unplugging

at the power extension cable. Disconnect at the

outlet socket.

The mains power cable must not be used for

fastening or transporting the pump.

Submersion and withdrawal of the pump should

be by means of the telescopic pipe.

Alternatively, a cord can be secured on

the telescopic pipe for submersing, lifting and

securing of the Rain Water Tank Pump.

Visual check

Please regularly check the connecting line. If the

connecting line of this appliance is damaged,

it has to be replaced by the manufacturer or the

manufacturer's aftersales service or a similarly

qualified person to prevent any hazards.

3. Assembly

Install / deinstall foot:

When the pump is to be used for draining for a flat container,

and is therefore placed on the ground, the foot can be

assembled so that the pump suctions less dirt. On delivery,

the foot is already assembled.

Install foot:

v From below, place the foot

locks

Deinstall foot:

v Press the two locks

4. Initial Operation

The telescopic pipe

transport position. The telescopic pipe is fitted with a GARDENA

Regulator Valve. We recommend the use of a GARDENA

Standard Hose Connector: Art. No. 2015/2915 for 13mm (1/2")

and Art. No. 2016/2916 for 16mm (5/8") and 19mm (3/4")

respectively, for connecting a garden hose. With the use of

19-mm-(3/4")-hose line, the pumping quantity is the greatest.

Before using, always subject the pump

(especially the power cables and the power

connections) to a visual inspection.

A pump which is damaged should not be used.

In the event of damage, have the pump checked

by GARDENA Service.

Safety Instructions

Observe the minimum water level in accordance

with the characteristics given for the pump.

Only Art. No. 1740: Allow the pump to run no

longer than one hour against a closed pressure

side.

Thermal overload protection switch

If overloaded, the built-in thermal protection for

the motor will switch the pump off. After cooling

down, the pump will start again automatically

(see 7. Trouble-Shooting).

Automatic ventilation

The Rain Water Tank Pump is fitted with a venting

outlet. The function of this venting outlet is to force

out any air which may be present inside the pump.

Small amounts of water flow out of the gap bet-

ween the threaded connection and the housing;

if the water level drops further down, water also

flows out the lower part of the housing. This is no

defect but occurs due to venting purposes.

on the pump until the two

click into place.

and pull the foot

from the pump.

is placed on the side of the pump in the

Pumping water from

The length of the telescopic pipe

containers:

a manner that the pump does not touch the bottom of the

container; this way, dirt in the container is kept away from the

pump.

1. Pull telescopic pipe

of the pump and screw onto the pump

connector

lies in the mating thread

telescopic pipe

2. Loosen threaded collars

telescopic pipe

3. Adjust telescopic pipe

the container.

The telescopic pipe can be adjusted

between 73 – 91cm.

4. Turn threaded collars

firmly again.

5. Attach mains cable

ment clip

6. Hang pump with telescopic pipe

the container.

7. Insert the power plug.

ATTENTION! The pump begins operating

immediately.

The shut-off valve

function of a water tap. With an open system (Micro-Drip-

System, Sprinklers), the hose may not be placed deeper than

the container as otherwise the water flows through the pump

from the container even when the pump is switched off.

Complete solution:

GARDENA Rain Water

Collection Filter

Art. No. 3820 / 3821

GARDENA Connecting Set

Art. No. 3815

GARDENA Cover for Rain

Water Tank

Art. No. 3801 / 3805

GARDENA Rain Water Tank

Art. No. 3800 / 3804

GARDENA Rain Water Tank

Pump Art. No. 1740 / 1742

Use in shallow vessels:

If the Rain Water Tank Pump is used in a shallow vessel, e. g. to

empty an inflatable children's pool, the telescopic pipe can be

removed and replaced by the GARDENA Threaded Tap Connector

26.5mm (G 3/4) – Art. No. 2901/2801. The hose connection

13mm (1/2"), 16mm (5/8") or 19mm (3/4") is made using the

Original GARDENA System or GARDENA Profi "Maxi-Flow"

System threaded hose connectors.

Use in deep containers:

For deeper containers (up to max. 7m), the pump can no longer be

hung on the telescopic pipe. The pump must then be attached

through a cord connected to the telescopic pipe and submersed

into the container.

should be adjusted in such

from the side

. Ensure that the washer

of the

to the height of

until they hold

with the attach-

on the telescopic pipe

into

in an operating pump takes on the