GARDENA Pressure Tank Unit electronic plus
with Dry-Running Safety 4000 /4, 4000 / 5
Translation of the original instructions from German.
Please read these operating instructions carefully and observe the notes given. Use the
instructions to familiarise yourself with the equipment, the operating controls, their correct
use, and the notes on safety.
For safety reasons, children under 16 as well as persons not familiar with these operating
instructions should not use this Pressure Tank Unit. Persons with reduced physical or
A
mental abilities may use the hedge trimmer only if they are supervised or instructed by a
responsible person.
Where to Use Your Pressure Tank Unit
Intended use
Liquids to be pumped
Please note
Temperature of the liquid
Safety instructions
A
Use of pump near
swimming pools
Mains power cables
16
v Keep these operating instructions in a safe place.
GARDENA Pressure Tank Units have been designed for private
use around house and garden. Pressure Tank Units are pre-
dominantly used for operating watering implements and systems
in private gardens.
The GARDENA Pressure Tank Units can be used for pumping
rainwater, tap water or chlorinated swimming pool water.
GARDENA Pressure Tank Units are not designed for continuous
operation (e.g. industrial application, continuous circulating
operation). Corrosive, easily combustible, aggressive or
explosive substances (e.g. petrol, petroleum, nitro thinner) as
well as food must not be pumped.
The temperature of the liquid to be pumped should not exceed
35 °C.
Pursuant to DIN VDE 0100 -702 and 0100 -738 use of the pump
nearby swimming pools and garden ponds and other similar
places is only permissible, if the pump is operated with a
residual-current device with a residual-current rating ≤ 30 mA.
The pump must not be operated when there are persons in the
swimming pool or garden pond. The pump must be located on
solid, even ground, protected from flooding. Take care that the
pump cannot fall into water.
➔ Please ask your electrician for his advice.
Mains power cables should not have a smaller cross-section
than a rubber sheathed cable of the designation H07 RNF.
Extension cables must meet the requirements of DIN VDE 0620.
페이지 인쇄