Gardena 4000/5 Inox 사용 설명서 - 페이지 5

{카테고리_이름} Gardena 4000/5 Inox에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 4000/5 Inox 8 페이지. Submersible pressure pump

페이지 인쇄

5. Cleaning

Cleaning the inlet sieve

and suction base :

6. Trouble-Shooting

Problem

Pump is running,

but doesn't deliver.

Pump doesn't start or

suddenly stops during

operation.

Pump runs, but output

suddenly decreases.

The pumps are virtually maintenance-free.

Warning ! Electric shock !

Risk of injury due to electric shock.

V Disconnect the pump from the mains before clean-

ing the suction base.

1. Press in the 3 rear catches

pull the lower part of the suction base

2. Clean the suction base and inlet sieve.

3. Push the lower part of the suction base

back onto the pump until the 3 rear catches

For safety reasons a damaged turbine can only be exchanged

by the GARDENA Service Centre.

Probable cause

Air cannot escape, since

pressure line is closed.

Air locks in the suction base.

Suction base is clogged.

When starting the pump,

water height falls below the

min. water level.

Thermal overload switch has

switched the pump off due

to overheating.

No power.

Dirt particles are jammed

in the suction base.

Suction base is clogged.

(e.g. using a screwdriver) and

off the pump.

with the inlet sieve

snap into place.

Remedy

v Open pressure line

(e. g. kinked pressure pipe).

v Wait for max. 60 seconds

until the pump deaerates

automatically over the vent

valve. If necessary, switch

off and start it again.

v Disconnect plug and clean

suction base (see 5. Clean-

ing).

v Submerge pump deeper.

v Disconnect plug and clean

suction base (see 5. Clean-

ing).

Observe max. media temper-

ature of 35 °C.

v Check fuses and electric

connections.

v Disconnect plug and clean

suction base (see 5. Clean-

ing).

v Disconnect plug and clean

suction base (see 5. Clean-

ing).