Gardena 6000 S 사용 설명서 - 페이지 3

{카테고리_이름} Gardena 6000 S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 6000 S 12 페이지. Submersible pump/dirty water pump

페이지 인쇄

2. Safety Instructions

Electrical safety:

DANGER ! Electric shock !

The pump must not be operated if there are

people in the swimming pool or garden pond.

➜ Ensure that the electrical plug and socket

connections are fitted in an area which

cannot flood.

➜ Protect power plug from moisture.

According to DIN VDE (German Electrical

Engineers' Association) 0620, mains power

cables must not have a smaller cross-section

than the rubber-sheathed cables of the

designation H05 RNF. The cable length must

be at least 10 m.

Data indicated on the type plate must match

technical data of the mains supply.

According to DIN VDE 0100, pumps may only

be operated in swimming pools, garden ponds

and wells via a fault current circuit breaker with

a nominal fault current of

Swimming pools and garden ponds should be

designed according to international and natio-

nal design regulations.

For safety reasons we recommend that the

pump is always operated by a residual

-current device (DIN VDE 0100-702 and

0100-738).

➜ If in doubt please consult a qualified

electrician.

Protect plug and power cable from heat, oil

and sharp edges.

The connection cable of the pump cannot be

replaced. If the cable is damaged the pump

must be scrapped.

➜ Do not pull out the power cable from the

socket as a method of turning the pump off.

The power cable or the float switch must not

be used for mounting or relocating the pump.

For submerging or lifting/securing the pump,

fix a rope to the pump's carrying handle.

In Austria, according to ÖVE B/EN 60 555

parts 1 to 3, pumps which are used in

swimming pools and garden ponds, and

equipped with firm power cable should be

fed via an ÖVE approved isolating transformer

– rated voltage must not exceed 230 V.

In Switzerland mobile appliances which are

used outdoors must be connected via a

residual-current device.

30 mA.

Operating instructions:

➜ Before operating the pump look to see if

there is any damage to the pump (especially

to the power cable and plug).

➜ Clear the outlet line before use. Avoid

running the pump with the outlet side

closed off for more than 10 minutes.

against closed delivery side of the pump.

➜ Observe the minimum water level and the

max. delivery height (see 8. Technical

Data).

A damaged pump must not be used.

➜ In case of damage, please have the pump

checked by our GARDENA Service Centre.

Dry-running operation causes increased wear

and is to be avoided. Therefore, in manual

operation the pump must be immediately

unplugged when water fails to flow.

➜ Observe the pump at all times during

manual operation.

Take care that the pump is located where

the inlet openings at the suction base are not

obstructed neither completely nor partly.

Stand the pump on a brick if using in a pond.

Safety instructions:

Thermal motor protector:

The pump is automatically switched off on

overheating by the built-in thermal motor

protector. After having cooled down, the

motor automatically switches on again (see

7. Troubleshooting).

Automatic Air bleed valve:

The automatic air bleed valve eliminates any

air pockets in the pump. During this process,

air escapes through the vent bores

bubbles appear underwater. This is not a

defect of your pump, but serves to deaerate

the pump, but serves to remove air from the

pump.

and air

It may take several

seconds for the air to

escape when the pump

is immersed for the first

time.