Gardena 6500 SP 사용 설명서 - 페이지 6

{카테고리_이름} Gardena 6500 SP에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 6500 SP 10 페이지. Dirty water pump

페이지 인쇄

Manual operation :

5. Cleaning

Flushing the pump :

Cleaning the suction

base and feed impeller :

6. Trouble-Shooting

Problem

Pump is running,

but doesn't deliver.

The pump remains in constant operation because the float switch

is bypassed.

1. Push the float switch

cable downward.

2. Stand the pump on a firm surface

– or –

use a rope attached through the bore hole in the carrying

handle

3. Plug the power cable

The residual water height is only reached during manual opera-

tion since the float switch turns off the pump during automatic

operation before this water level is reached.

The pumps are virtually maintenance-free.

After having pumped chlorinated swimming pool water or other liq-

uids leaving residues, the pump should be rinsed with clear water.

Warning ! Electric shock !

Risk of injury due to electric shock.

V Disconnect the pump from the mains before clean-

ing the suction base and feed impeller.

1. Unscrew the 6 Phillips screws

screws) and pull the suction base

2. Clean the suction base

3. Reinstall the suction base

For safety reasons a damaged feed impeller

exchanged by the GARDENA Service Centre.

Probable cause

Air cannot escape, since

pressure line is closed.

Air locks in the suction base.

Feed impeller clogged.

When starting the pump,

water height falls below the

min. water level.

onto the float switch lock

to immerse the pump in a well or shaft.

into a mains socket.

and the feed impeller

and screw in the Phillips screws

Remedy

v Open pressure line

v Wait for max. 3 minutes

v Disconnect plug and clean

v Submerge pump deeper.

with the

(model 6500 SP: 4 Phillips

off the pump.

can only be

(e.g. kinked pressure pipe).

until the pump deaerates

automatically over the vent

valve. If necessary, switch

off and start it again.

feed impeller (see 5. Clean-

ing).