Gardena 8500 aquasensor 사용 설명서 - 페이지 6

{카테고리_이름} Gardena 8500 aquasensor에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 8500 aquasensor 14 페이지. Submersible pump/dirty water pump
Gardena 8500 aquasensor에 대해서도 마찬가지입니다: 운영자 매뉴얼 (14 페이지), 운영자 매뉴얼 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (13 페이지), 사용 설명서 (14 페이지), 운영자 매뉴얼 (14 페이지), 사용 설명서 (14 페이지), 사용 설명서 (15 페이지), 사용 설명서 (11 페이지)

Manual operation :

Only for the

submersible pump 7000 :

Flat suction /

Normal operation

5. Putting into Storage

Frost-free storage :

Disposal :

(in accordance with

RL 2002 / 96 / EC)

The pump remains in constant operation because the float switch

is bypassed.

1. Push the float switch

cable downward.

2. Stand the pump on a firm surface

– or –

use a rope attached through the bore hole in the carrying

handle

3. Plug the power cable

The residual water height is only reached during manual

operation since the float switch turns off the pump during

automatic operation before this water level is reached.

Flat suction :

v Turn the 3 swivel feet

180° to 1 mm.

The residual water level of approx. 1 mm is only reached during

flat suction in the manual operation mode. If the water level is

lower than 25 mm, you can accelerate flat suction by switching

the pump off and on 2 to 3 times.

If the water height is lower than 3.5 cm, fill the pump before

operation over the universal fitting

v Store the pump away from frost before the first frost sets in.

The product must not be added to normal household waste. It

must be disposed of in line with local environmental regulations.

v Important: Make sure that the unit is disposed of via your

municipal recycling collection centre.

onto the float switch lock

to immerse the pump in a well or shaft.

into a mains socket.

Normal operation :

v Turn the 3 swivel feet

with the

180° to 5 mm.

with water.