Gardena FP 7500 E 사용 설명서 - 페이지 3

{카테고리_이름} Gardena FP 7500 E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena FP 7500 E 13 페이지. Submersible pump / dirty water pump
Gardena FP 7500 E에 대해서도 마찬가지입니다: 사용 설명서 (14 페이지), 사용 설명서 (14 페이지)

페이지 인쇄

The pump must not be operated when there

are people in the water. Swimming pools and

garden ponds should be designed according to

international and national design regulations.

v Please consult a professional electrician.

For Austria :

Pumps for use on swimming pools and on

ponds may only be operated via an isolating

transformer.

v Please consult a professional electrician.

For Switzerland :

In Switzerland mobile appliances which are

used outdoors, must be connected via a resi-

dual-current device.

Note :

Do not allow the pump to run without water

because dry-running leads to an undesira-

ble build up of heat.

3. Assembly

Fit the pump :

VARIANT 1 : Mount the

additional filter on the pump :

To provide a firmer mounting, the filter housing can be attached to

a solid base (e.g. paving stone).

1. Screw nozzle pipe

joint.

2. Screw the water feature insert you require (a / (b / (c / (d on

the nozzle pipe

All pumps

(a cascade

Holder for GARDENA underwater light art 7951

The additional filter can be fitted on the filter housing to extend the

maintenance interval and to give the water feature a longer life.

1. Remove the cap

2. Fit both filter shells

place.

3. Press sealing cover

4 a

You can install additional filters

Additional filters are available from GARDENA Service.

Before operating the pump, look to see if there

is any damage to the pump (esp. regarding

power cable and plug). The connection cable

of the pump cannot be replaced. If the cable is

damaged the pump must be scrapped. Ensure

that the power cable cannot be crushed if it

has not been laid in conduit in the earth or in

gravel.

Do not use the power cable to carry the pump

or to pull the plug out of the socket.

Protect the power cable from heat, oil and

sharp edges.

The temperature of the liquid used must not

be below 4 °C or above 35 °C.

Sand and other abrasive substances in the

liquid cause increased wear and reduce the

output of the pump.

Please observe the local noise prevention

regulations.

on to the pump with the ball and socket

art. 7650

- 7654

(b Waterbell

(c jets of

water

from the pump.

on the filter housing

on to the additional filter

to increase the filter surface.

art. 7655 - 7657

(d foaming -

spring

and clip into