Gardena RP 600 사용 설명서 - 페이지 6

{카테고리_이름} Gardena RP 600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena RP 600 20 페이지. Indoor fountain pump
Gardena RP 600에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)

페이지 인쇄

Commissioning the pump if

it is installed out of water :

If the pump is installed out of water, the filter housing

be taken off.

1. Pull off the filter housing

2. Turn the pump inlet

the motor housing

3. Depending on the pumping application, the pump inlet can be

rotated in 90° steps. Twist the pump inlet

press it vertically on to motor housing

wise (see 5. Cleaning).

4. Screw stepped nipples

outlet

5. Connect the pump inlet

(1/2 " or 3/4 " ) . The level in the water reservoir must be

higher than the pump inlet

6. Connect the pump outlet

(1/2 " or 3/4 " ) .

7. Fill the hose to the pump inlet

8. Insert the pump plug into a mains socket.

Caution : The pump will start immediately.

9. Use the flow control

spring.

anticlockwise and pull it vertically off

(bayonet socket).

on to the pump inlet

to the water reservoir with a hose

to the spring / gargoyle with a hose

with water.

to set the desired water flow for the

must

accordingly, again

and tighten it clock-

and pump